Table of Contents
Advertisement
English
Wall Mounting
These chargers are designed to be wall mountable or to
sit upright on a table or work surface. If wall mounting,
locate the charger within reach of an electrical outlet,
and away from a corner or other obstructions which may
impede air flow. Use the back of the charger as a template
for the location of the mounting screws on the wall. Mount
the charger securely using drywall screws (purchased
separately) at least 1" (25.4 mm) long, with a screw head
diameter of 0.28–0.35" (7–9 mm), screwed into wood to an
optimal depth leaving approximately 7/32" (5.5 mm) of the
screw exposed. Align the slots on the back of the charger
with the exposed screws and fully engage them in the slots.
Versatrack
CRAFTSMAN chargers can be mounted to the wall using
CRAFTSMAN Versatrack Trackwall. Hooks and accessories
are sold separately. Please refer to the Versatrack Trackwall
accessory sheet for further information.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.
Refer to Figure A at the beginning of this manual for a
complete list of components.
Intended Use
This speaker is designed for household use.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Inserting and Removing the Battery Pack
from the Bluetooth® Speaker (Fig. B)
nOTE: Make sure your battery pack
To Install the Battery Pack into the Unit
1. Align the battery pack
radio's battery port
11
2. Slide it in until the battery pack is firmly seated and
ensure that you hear the lock snap into place.
6
is fully charged.
10
with the rails inside the
10
(Fig. B).
To Remove the Battery Pack from
the Unit
1. Press the battery release button
battery pack out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
Fig. B
12
OPERATION
Warning: To reduce the risk of serious personal injury,
turn unit off and disconnect it from power source
and remove the battery pack before making any
adjustments or removing/installing attachments
or accessories. An accidental start-up can cause injury.
Instructions for Use (Fig. C)
WARNING: Always observe the safety instructions
and applicable regulations.
Power Button
1. To turn on the speaker, press the power button
2. To turn the speaker off, press the power button
Volume Adjustment
When the charger/speaker is paired to a Bluetooth® device
the increase and decrease volume buttons
to increase or decrease volume on the audio device.
Track Change
When the charger/speaker is paired to a Bluetooth® device
the right and left arrow buttons
to previous tracks on the audio device.
12
and firmly pull the
10
11
1
.
1
.
can be used
2
can be used to skip or go
3
Hide quick links:
Advertisement
Table of Contents
