Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cyfral Cosmo
Summary of Contents for Cyfral Cosmo
- Page 1 The manual of the assembly and service of the COSMO intercom...
- Page 2 We believe that good quality and functionality of the product will meet your expectations. 1. COSMO unit The COSMO unit is a solution where duplex signal transmission were applied and the connection of the headset uniphone and instruction panel were made with two conductor line.
- Page 3 • Wires of electromagnetic clamp to the terminals ZACZEP. • Uniphone “hot” (+) end of the clamp UN1 and “cold” (-) end to the unit chassis ground marked as MASA. Fig. 1 The span of assembly openings of the unit including outdoor wall cover. The dimension of the openings: 5 mm WARNING: •...
- Page 4 Fig. 2 The diagram of the unit connection with remaining elements of the intercom system and the overlay of the electronics plate with the connection description. 2.3 List of tenants In order to prepare a list of tenants it is necessary to disassembly aluminum panel, advance plastic cover down and the frame of tenants list.
- Page 5 The holder of the SMART intercom unit can be quickly disassembled, two parts of the cover are connected with one screw installed under the headphone speaker. In order to disassemble the cover, the screw must be unscrewed, afterward grab the cover edge of the holder in its upper part and pull.
- Page 6 Maximum load: 200mA 12V AC/DC 5. The system operation. • COSMO intercom unit serves one tenant. • Pressing the button on a panel causes the call of a uniphone of selected tenant. • Ringing tone is heard upon twice pressing of a button.
- Page 7 6. Procedure of RFID pendants programming The COSMO intercom unit is equipped with the reader of RFID proximity pendants. The reader is located directly under the backlit window of a business card. In order to activate the grabble or program RFID pendant it is necessary to close it the window of a business card to the distance of approx.
- Page 8 The unit remains in the programming mode by 10 sec. every closing of a key prolongs the time by next 10 sec. 7. Programming of the time of electric doorstrike opening The default setting is 4 sec. It can be adjusted within 1-15 sec. To set new time, the following steps shall be done: Start “programming remaining pendants”...
- Page 9 WE WISH YOU PLEASANT USAGE!
Need help?
Do you have a question about the Cosmo and is the answer not in the manual?
Questions and answers