Replacing A Nim1060 With A Nim1200 Module In Cluster Nodes - Hitachi 2000 Series Hardware Reference Manual

8. Restart the server.
9. Once the server has booted, verify that the links are up on the newly connected
10 GbE ports.
It might be necessary to make configuration changes to the 10 GbE switch for the
ports used to match the previous NIM 1060 configuration; for example, the use of
LACP or not, and so on.
Note: If the server fails to boot, it might be that the NIM1200 was supplied
without an SSLoader. To make the server boot again, it will be necessary to
upload the SSLoader onto the new NIM module using the serial connection
or Xmodem. Refer to the Hitachi High-performance NAS Platform System
Installation Guide for instructions on using SSLoader.
10. Using the console, reconnect to the required server by selected it from the
displayed menu.
11. Upgrade the aggregation information on the server by entering the following
command:
agg-upgrade

Replacing a NIM1060 with a NIM1200 Module in Cluster Nodes

To upgrade from a NIM 1060 to a NIM 1200 in cluster nodes:
1. Back up the server configuration (registry).
Using Web Manager, log in to the server/cluster node to be upgraded, and select
Server Admin > Configuration Backup & Restore.
2. Record the IP address through which the SMU is managing the server/cluster. The
IP address is displayed in the Server Status Console with the managed server or
cluster name.
3. Send any diagnostics to your support organization before and after swapping the
modules.
To send diagnostics to support:
a. Log in to Web Manager.
b. From the Home page, select Status & Monitoring > Download
Diagnostics.
c. Click email.
4. Log in to the server through the SMU.
Using Web Manager, log in to the server/cluster node to be upgraded, and select
SMU Administration > SSHTerm. Start SSHTerm, log in as "manager" and
select the server from the displayed menu. This will display the console, which you
can use to enter CLI commands on the server to complete the following steps:
Note: Refer to the Hitachi High-performance NAS Platform Command
Line Reference for more information on the commands used below.
30 Hitachi High-performance NAS Platform