Configuring The Mobile Panel - Siemens SIMATIC HMI Series Operating Instructions Manual

Configuring the Mobile Panel

This section contains important information on configuring the Mobile Panels and connection
boxes. The following overview shows required and optional configuration steps for the
various device types.
Configuration in WinCC
•
•
•
Configuring fail-safe function blocks
•
Configuring plant areas in WinCC
•
•
Additional configuration options in WinCC
•
•
•
Controlling and evaluating operator controls and display elements
•
•
•
•
Fail-safe Mobile Panels
NOTICE
Avoiding PLC STOP
The replugging a fail-safe HMI device without logoff can lead to a communication error
message. To avoid a PLC STOP in such cases, use the required organization blocks. You
can find additional information in the following FAQ:
Which organization blocks can be used in STEP 7 (TIA Portal)?
(https://support.industry.siemens.com/cs/ww/en/view/40654862)
Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC
Adding a controller to the project (Page 167)
Adding the Mobile Panel to the project (Page 169)
Configuring a fail-safe Mobile Panel (Page 170)
Configuring F-FBs in STEP 7 (Page 174)
Configuring connection point detection (Page 179)
Configuring zones and start screens (Page 181)
Configuring function and direct keys (Page 182)
Setting the transfer mode (Page 183)
Changing the operating mode (Page 183)
Evaluating operator controls as direct keys (Page 184)
Controlling the LEDs of the function keys by means of
system functions (Page 187)
Controlling and evaluating the illuminated pushbutton
by means of system functions (Page 187)
Evaluating the key-operated switch by means of sys-
tem functions (Page 188)
Required for All Mobile Panels
Required for All Mobile Panels
Required for Fail-safe Mobile Panels
Required for Fail-safe Mobile Panels
Optional for All connection boxes
Optional for All Mobile Panels
Optional for All Mobile Panels
Optional for Fail-safe Mobile Panels
6
165