FujiFilm DRYPIX 2000 Service Manual page 474

n Installing from the USB Memory
1.
Remove the LAN cover and open the blind plate.
CAUTION
When touching the blind plate of the USB connector, be sure to use a wristband
to ground yourself. Otherwise the equipment may not operate properly.
2.
Connect the USB memory to the USB connector of the CPU board.
3.
Select the installation type.
• [Upgrade]: Version upgrade
• [Full Install]: Full installation
4.
[Are you sure?] →
→ T he data in the USB memory is loaded in the equipment. When installation
completes normally, "Completed." is displayed.
5.
Check that "Completed." is displayed and remove the USB memory.
6.
Reinstall the removed plate and the LAN cover.
7.
Reboot the equipment so that the changes made in the main unit
software become effective.
016-201-04E
02.15.2007 FM5075
8.
If full installation has been performed, perform the following procedure
as well.
(i) Restore the individual data.
(ii) Reboot the equipment.
(iii) Set the system date and time.
(iv) Set the number of remaining films.
(v) Set the total film counter.
<IMPLEMENTATION OF CHANGES>
The changes made will be effective after the equipment is rebooted.
DRYPIX 2000 Service Manual
MU-25.2
MU-25.2