Appendix Ii: Instructions For Software Upgrading Operation Of Sf-2012Ah - Beijing StarFire Control Technology Co., Ltd. SF-2012AH-QG User Manual

Beijing Starfire Control Technology Co.,Ltd.

Appendix II: Instructions for Software Upgrading Operation of SF-2012AH

Functions:
The system software is allowed to upgrade through an USB disk.
The specific operation procedure is as follows:
1.File upgrading
Copy the upgrading file titled STARTCNC.EXE to an USB disk.
2.Operation procedure
Push and hold the button between the
Power the system on and release the
display screen. Plug the USB disk into the port and press Key F1 under the display screen(the key
corresponds to "UPGRADE" in the menu displayed). The system will automatically start
upgrading operation.
3.Upgrading end
If program upgrading is successful, the system will prompt "Upgraded Successfully" and sound
one beep. If program upgrading fails, the system will prompt "Upgrade Failure" and sound
continuous beeps. 。
4.New program startup
Power the system off and unplug the USB disk. Reboot the system to start up the upgraded
program. The version number of the upgraded program will appear on the screen after booted up.
Notes:
Please make the following check if upgrading operation fails.
1) The USB disk must be FAT or FAT32 format. FAT format is preferable.
2) The upgrading file must be titled as STARTCNC.EXE.
3) If no prompt appears in the upgrading process and the display returns to the main upgrading
window or upgrading operation fails due to any other interruption, verify first the name of upgrading
file and the format of USB disk. If these two factors are assured, try to upgraded the program again
following the specific operation procedure.
If program upgrading failure insists, please contact the Customer Service Department of
Control Technology Co.,Ltd.
Model SF-2012AH-QG
Cutting Machine（C002）
北京斯达峰控制技术有限公司
red button 0 and the USB port.
button when upgrading window appears on the
Beijing Starfire
37