Y-Solar T10 Series User Manual

T10/T20/T30/T40 User Manual
This is a three-time controller into the evening (evening) working time, an interval of rest or
pause time, Dawn working time (morning light function), the user can according to their
needs, set a different time.
This is a compatible MPPT charge controller PWM intelligent / efficient / energy saving, he
not only has efficient MPPT controller charging function to automatically track the
maximum power point, 10% -30% higher than the ordinary controller charging efficiency,
also has standby energy saving, more than 30% energy than ordinary controller, the
standby power consumption of only 10mA-15mA.

1:Product introduction

"T" series of an intelligent, multi purpose solar charge controller
LCD screen display
Simple (and more time control) operation
MPPT+ PWM charging mode
Parameter user can reset
A key to open and close the load
A key to restore the factory settings

2: Installation Instructions

Installation（Installing wires, first loosen the screw counterclockwise）
Ready installation tools and materials, and cable. Please
1
matching suitable cable
ensure that the current density <4A/mm2 This will help reduce the
2
line pressure drop.
Check the installation site meets the relevant safety requirements, avoid damp,
dusty, flammable, explosive and corrosive gases
Install the controller fixed to the vertical plane, see Section V mounting aperture and
3
hole spacing. In order to ensure a good controller cooling conditions, the controller
on the bottom of each reserved 10cm space
As shown on the right wiring sequence: load, battery, solar
4
Battery plate is connected to the controller to be taken to ensure that the load,
battery,
The polarity of the solar cell panel and controller
Battery reverse discharge protection
Battery reverse polarity protection
Battery under voltage protection
Overload, short-circuit protection
Automatic temperature
function
USB5V charge (current 500mA) Optional
compensation