Table of Contents
Advertisement
Verifying Operations with Demos
Dolphin terminals contain Demos you can use to verify imaging and decoding.
Verify Imaging
The Image Demo enables you to use the imager to capture an image.
1. Tap Start > Demos > Image Demo. The Image Demo opens.
2. Point the terminal at an object and press the SCAN key. A preview of the
object appears on the screen, and the decode and scan LEDs light.
3. Release the SCAN key. The image is captured.
By default, images save to the My Device folder as "imagedemo.jpg." To
save to a different location, tap File > Save As and select a new location.
4. Press the ESC key to close the demo.
For more information about taking an image, see
Verify Decoding
The Scan Demo enables you to decode bar codes.
1. Tap Start > Demos > Scan Demo.
2. Aim the terminal at a bar code and press the SCAN key. The scan LED lights
red, and the aimer beam or pattern projects out from the scanner.
3. When a good scan is obtained, the decode LED lights solid green and the
terminal beeps. The bar code readout appears on the screen.
4. Press the ESC key to close the demo.
Sample Bar Codes
Use the following bar codes to verify decoding:
Sample 128
"Code 128"
Note: Dolphin 9501/9551 terminals support only 1D symbologies; use Code
128 to verify scanning.
For more information, see
10
Decoding a Bar Code
Dolphin® 9500 Series Quick Start Guide
Using the Imager
Sample PDF417
"PDF417 Test Message"
on page
18.
on page
18.
Advertisement
Table of Contents
