Advertisement
Quick Links
Advertisement
Related Manuals for RP3 Rowing RP3 Dynamic
Summary of Contents for RP3 Rowing RP3 Dynamic
- Page 1 Manual for RP3 and RP3S www.rp3rowing.com 1 / 19...
- Page 2 1.Introduction The RP3 Dynamic rowing simulator is the world's only rowing machine that truly simulates the dynamics of a light racing shell, freely floating on the water. The main frame with its flywheel, stretcher and seat are the boat simulating parts, and the main bar simulates the water.
- Page 3 Wear tight clothing and keep clothing free from the seat rollers. Maintain your machine properly as recommended in section Maintenance. Replace worn or defective parts before using the unit. In general: Treat your RP3 rowing simulator with the same loving care as you would your single scull. 3 / 19...
- Page 4 3. Assembly of the base unit. The RP3 rowing simulator comes pre-assembled into 7 separate parts: - Mainframe assembly - Main bar - Seat - Front Leg - Rear leg - Foot stretcher - Box with tools and other parts Tools needed: inbus key 6 mm and spanner size 13 for M8 nuts Assembly procedure.
- Page 5 The clearance between the main bar and the rollers of the main frame has been adjusted in the factory. However, prior to using the units please check the clearance as per section 4.Maintenance and adjust if necessary. 5 / 19...
- Page 6 4. Maintenance. General: To get the most satisfaction from your RP3 rowing simulator, treat her with the same loving care as you would your single scull. The actual level of maintenance required can vary strongly depending upon the type and frequency of use, and the environment the machine is used in.
- Page 7 Generally repeated cleaning and lubrication, as in weekly maintenance, will loosen up the links. If this is not the case and the chain skips over the sprocket, the unit should not be used. Contact your RP3 Dynamic agent for a replacement chain and sprocket.
- Page 8 The flywheel assembly of the RP3 rowing simulator weighs 21.8 kgs, which is close to the average weight per person of most racing shells, including the oars.
- Page 9 Actions prior to start-up. Connect the interface with the Tablet by Bluetooth or with the cable or with a cable to one of the COM ports of the computer. Note: The interface derives its energy from a battery pack or if connected to the COM port, no batteries are needed.
-
Page 10: Warranty
To be considered for warranty replacement or repair, the defective parts must be returned, postage paid, to RP3 rowing BV, together with a description of how the piece failed and the serial number of the machine The customer is responsible for all shipping costs. - Page 11 For more information on RP3 Rowing write or call to one of the following addresses: RP3 Rowing BV Textielstraat 2e 7483 PB Haaksbergen For the agents see website: The Netherlands www.rp3rowing.com Tel. +(31) 85 2734931 E-mail info@rp3rowing.com Jan and Annet Lammers Subject to change without notice.
- Page 12 Picture 1 Picture 2 2 / 19...
- Page 13 Picture 3 Picture 4 3 / 19...
- Page 14 Picture 5 Picture 6 picture 7 4 / 19...
- Page 15 picture 8 Picture 9 5 / 19...
- Page 16 Picture 10 Picture 11 6 / 19...
- Page 17 Picture 12 Picture 13 7 / 19...
- Page 18 Picture 14: Content box 8 / 19...
- Page 19 9 / 19...
Need help?
Do you have a question about the RP3 Dynamic and is the answer not in the manual?
Questions and answers