Sony MAV-555SS Operation Manual page 65

Item number Display indication
806 SHUTTLE MUTING
BI
809 AUDIO MONITOR MUTING
820 AUDIO OUTPUT MIXING
BI
821 AUDIO OUTPUT CHANNEL P1
822 AUDIO OUTPUT CHANNEL P2
823 AUDIO OUTPUT CHANNEL P3
BI
SUB MENU
CHANNEL 1
CHANNEL 2
CHANNEL 3
CHANNEL 4
824 AUDIO EDIT PREVIEW
BI SWITCHER
827 AUDIO OUTPUT PHASE P1
828 AUDIO OUTPUT PHASE P2
829 AUDIO OUTPUT PHASE P3
BI
880 INTERNAL AUDIO SIGNAL
GENERATOR R1
881 INTERNAL AUDIO SIGNAL
GENERATOR R2
882 INTERNAL AUDIO SIGNAL
BI GENERATOR R2
883 EMPHASIS ON/OFF R1
884 EMPHASIS ON/OFF R2
BI
886 RATE CONVERTER R1
887 RATE CONVERTER R2
888 RATE CONVERTER R3
BI
950 SS CAMERA SELECT
B
951 SS AUDIO INPUT DELAY
BI ADJUST
Expansion menu items (Continued)
Settings Description
This item specifies audio muting during shuttle operations.
off : Audio is always output.
on : Muting is always applied.
This item specifies the muting of the audio output from the audio monitor.
normal : Outputs audio normally.
muting : Mutes the audio output.
This item specifies the mixing method when mixing the audio output by the PB ports.
add : Simple addition
average : Average
rms : Root mean square
These items make the settings for substituting, mixing and outputting the audio
output by the PB ports on each channel.
Select from among none, 1
1234. The displayed channels are mixed and output.
Select from among none, 1,
1234. The displayed channels are mixed and output.
Select from among none, 1, 2, 12,
1234. The displayed channels are mixed and output.
Select from among none, 1, 2, 12, 3, 13, 23, 123,
1234. The displayed channels are mixed and output.
Sets the output phase of the Audio playback signal for the Edit Preset Status.
internal : Matches the output phase during EE. Set when previewing the
MAV-555SS or while monitoring the VTR output signal.
external switcher : Matches the internal or external video code. Set when switching the
signal with the external switcher and Previewing.
Sets the output timing of the audio playback signal (SIF, AES/EBU only). With 0x100 as
the reference, as it becomes smaller, the output timing comes earlier, and as it becomes
larger, the output timing comes later.
0×000 .. 0×100 .. 0×1ff
Selects the device to generate the internal audio test signal.
off : No audio test signal is generated.
silence : Silent signal.
1 KHz sine : Generates a sine wave of 1KHz - 20dB FS.
1 KHz-9 dB : Generates a sine wave of 1KHz - 9dB FS.
When not off
For any selection other than "off", press the INPUT SELECT button on the front panel to
switch the button on, and then press and hold down the CH1 AUDIO INPUT button for 3
sec. or more to switch all of the digital audio input signals for all channels to the internal
audio SG.
When the BKMA-513 optional board is installed, these items enable and disable pre-
emphasis for each individual port.
on
off
Specifies whether an audio AES/EBU rate converter is used.
enable : Uses a rate converter.
disable : Does not use a rate converter.
Sets the input video format from cameras that support Super Slow.
sony : Records video signals from standard format Sony cameras.
other : Records video signals from cameras other than standard format Sony
cameras.
Sets the timing of the input audio signal with Super Slow recording.
000 .. 100 .. 1FF
Note:
If you set SS LIP SYNC ADJUST (menu 953) to on, be sure to adjust this
setting.
, 2, 12, 3, 13, 23, 123, 4, 14, 24, 124, 34, 134, 234, and
2 , 12, 3, 13, 23, 123, 4, 14, 24, 124, 34, 134, 234, and
3 , 13, 23, 123, 4, 14, 24, 124, 34, 134, 234, and
4 , 14, 24, 124, 34, 134, 234, and
3-39 (E)
3-4 Setup