Update Firmware - Holley Sniper EFI HyperSpark Manual

UPDATE FIRMWARE:

NOTE: To use a HyperSpark Distributor with a Sniper, the system must be using these versions of firmware or later:
Handheld: 1.1.7 (tslcd35st_sniper_fw_01_01_0070.fwu)
ECU: 1.1.1 (SNIPER_01010000.eep)
Software: Version 1.1 Build 2
ECU Firmware: From Main Screen. Files>ECU HW/FW
Handheld Setup:
For New Sniper EFI Installations:
From the HOME Screen select Wizards, follow the prompts, on Step 7 you will be prompted to select your ignition type,
highlight Hyperspark Distributor (Figure 6), and press Next. Then follow the wizard prompts in the Sniper EFI handheld to
complete the setup Wizard.
Or:
If you already have a running engine with Sniper EFI and are upgrading the ignition system. Instead of re-running
the wizard, you can manually change your ignition type.
From the HOME Screen, select Tuning, next select System, then Ignition Setup, now press Ignition Type, and
select HyperSpark.
Handheld Firmware: From Main Screen. Files> Local Setup
Figure 6
4