Safety Information Restrictions This product is designed for indoor floor cleaning only. Please do not use it outdoors (such as an open-ended terrace), on any surface instead of the ground (such as a sofa), or in a commercial or industrial environment Please do not use the product on any elevated surface without barriers (such as the floor of a loft, an open-ended terrace and the surface of furniture Please do not use the product when the temperature is higher than 40℃...
Page 4
Safety Information This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Page 5
WARNING For the purposes of recharging the battery, only use the detachable supply Unit xiaowa CDZ03RR or CDZ04RR provided with this appliance Do not arbitrarily dismantle, repair or modify the battery or dock charger Please keep the dock charger away from heat (such as heating plates)
Malfunction of the main brush, the side brush, the fan or the main wheel Dock Charger Failure of charging the main unit Power cable Failure of supply electricity to the dock charger Dock Charger xiaowa CDZ03RR/ CDZ04RR Xiaowa Rechargeable Li-on battery pack information BRR-1P4S-2600S/BRR-1P4S-2600D BRR-2P4S-5200S/BRR-2P4S-5200D 2600mAh/37.44Wh...
Page 7
Introduction Machine Spot cleaning Press to start spot cleaning Clean/ON&OFF Press to start cleaning Press and hold to power on or off POWER light White: battery capacity ≥ 20% Red: battery capacity < 20% Slow flashing: Charging or starting up Flashing in red: Faulty state Recharge Press to start recharging...
Page 8
Introduction Part list Water tank Mopping cloth Moistureproof mat Main brush cleaning tool Power cable Dock charger...
Page 9
Introduction Dust bin Machine Dust bin cover Dust bin buckle WIFI indicator Slow flashing: Waiting for connection Fast flashing: Connecting Strainer Glowing: WIFI is connected Air outlet Speaker...
Page 10
Introduction Machine and sensor Dock charger Dock charger indicator Signal transmitting area IR decelerate sensor Power connector Charge tab Charge tab Cliff Sensor Omni-directional Omni-directional wheel recharge sensor Charging contact pieces Bumper Motion tracking sensor Side brush Main wheel Main brush Main brush cover buckle...
Installation Clip the dock charger into the groove of the Power on and charge waterproof mat and install it in place Press and hold the key to power on, wait until the power light is normally on, and then dock the machine body to the dock charger for charging The machine is equipped with a built-in high performance lithium-ion rechargeable battery pack.
Installation The product is compatible with Mi Home intelligent platform and could be controlled by Mi Home app. It supports the MIUI system and can be interconnected with other Mi Home intelligent products Quick Setup Download App Search "Mi Home" in App store/Google play or scan the QR code below to download and install the Mi Home app. Add Device Go to "My Device"...
Page 13
Installation Install the mopping cloth: dampen the mopping cloth and squeeze it dry. Insert it to the end along the slot of the water tank and stick it firmly WIFI indicator Slow flashing: Waiting for connection Fast flashing: Connecting Glowing: WIFI is connected Note: When your mobile phone fails to connect to the machine, Note: Do not use the mopping module when there is nobody at home please refer to "User Manual"...
Routine Maintenance Installation Start cleaning Main brush Clean weekly 1. Flip the machine over and push the buckle to remove When the power light changes from white breathing flash to the main brush cover normally on, charging completes. Press the key or use your 2.
Page 15
Routine Maintenance Dust bin and strainer Clean the washable strainer Clean weekly Clean every two weeks 1. Open the dust bin cover as indicated by arrow 1. Remove the top cover of the machine and press the dust bin buckle to lift up and remove the dust bin 2.
Page 16
Routine Maintenance Side brush Clean monthly 3. Remove the filter and rinse with water 1. Flip the machine over to remove the fixing screw on the side brush 2. Remove and clean the side brush 3. Reinstall the side brush and tighten the screw Note: It is recommended to replace the side brush every 3-6 months to ensure the cleaning effect Note: Do not touch the surface of the filter with hands, brushes or sharp...
Page 17
Routine Maintenance Mopping cloth Filter assembly Clean after use Replace every 1-3 months 1. Remove the mopping cloth from the mopping module 1. Use your finger to remove the filter assemblies on the left and right along the notch 2. Install a new filter assembly in place Note: It is recommended to replace a filter assembly every 1-3 months to ensure the cleaning effect, depending on the quality of water and frequency of use.
Routine Maintenance Machine sensor Dock charger Clean monthly Clean monthly Use soft dry cloth to wipe and clean each sensor, including: Use soft dry cloth to clean the charging contact of the dock charger 1. Four cliff sensors on the bottom of the machine 2.
Basic parameters Machine Name Specs Specs , ( can be 0 to 9, A to Z, a to z, "-", , ( can be 0 to 9, A to Z, a to z, "-", ***** * ***** * Model "_", "\", "/" or blank,for marketing purpose.) "_", "\", "/"...
Page 20
Xiaowa Model Comparison Xiaowa Lite Xiaowa Xiaowa Plus Model ( can be 0 to 9, A to Z, Xiaowa C1 ***** Xiaowa E2 ***** Xiaowa E3 ***** to z, "-", "_", "\", "/" or blank, for marketing purpose.) Cleaning method...
Troubleshooting When a runtime error occurs, the power indicator flashes in red quickly and a voice prompt is given. Use the table below to solve the problem. Fault display Solution The bumper is stuck. Please lightly and repeatedly tap the bumper to Error 2: Please clean and lightly tap the bumper remove any foreign matter.
Page 22
Troubleshooting Error 12: Battery level is too low. Please recharge Low battery. Please charge it before use; Please use a dry cloth to wipe the charging contact of the machine and Error 13: Charging error. Please clean the charging the charging tab of the dock charger; contact areas The battery temperature is too high or too low.
EU Declaration of Conformity Hereby we: Name of manufacturer Beijing Roborock Technology Co.,Ltd. Floor6,Suite6016,6017,6018,BuildingC,Kangjian Baosheng Plaza, Address No.8 Heiquan Road,Haidian District, Beijing,P.R.CHINA declare that this DoC is issued under our sole responsibility and that the products: Product description Robotic Vacuum Cleaner and Accessories ( can be 0 to 9, A to Z, a to z, "-", "_", "\", "/"...
Page 24
EU Declaration of Conformity 1.Electromagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements; Harmonized Standard covering the essential requirements of article 3.1(b) of Directive 2014/53/EU and the essential requirements of article 6 of Directive 2014/30/EU RED Directive 2014/53/EU 2.Electromagnetic Compatibility (EMC) standard for radio equipment and services;...
Page 25
EU Declaration of Conformity 1.Household and similar electrical appliances-Safety-Part 1: General requirements Low Voltage Directive 2014/35/EU 2.Household and similar electrical appliances-Safety-Part 2-29: Particular requirements 1. EN 60335-1:2012 + A11:2014 for battery chargers 2. EN 60335-2-29:2004 + A2:2009 3.Measurement methods for electromagnetic fields of household appliance and similar 3.
WEEE Information Correct Disposal of this product . This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
Warranty Information The seller provides warranty in accordance with the legislation of the customer's own country of residence, with a minimum of 1 year,starting from the date on which the appliance is sold to the end user. The warranty only covers defects in material or workmanship. The repairs under warranty may only be carried out by an authorized service centre.
Page 28
Robotic Vacuum Cleaner Manufacturer: Beijing Roborock Technology Co., Ltd. Product Model: E2 ( can be 0 to 9, A to Z, a to z, "-", "_", "\", "/" or blank, for marketing purpose.) ***** ***** * Address of Manufacturer: Floor 6, Suite 6016, 6017, 6018, Building C, Kangjian Baosheng Plaza, No.
Need help?
Do you have a question about the Xiaowa Lite and is the answer not in the manual?
Questions and answers