Siemens SIMATIC S7-1500R/H Getting Started page 42

Display the status of the tunnel on the panel
An HMI screen is used to display the status of the tunnel on both Comfort Panels and to set
parameters. The white fields are used to show the current measured values of the sensors.
By double-clicking on the "Air parameters" and "Lighting parameters" buttons, you can
display and change the parameter settings.
By double-clicking on the symbols for lamp and motor, you access the automatic / manual
operating mode.
By double-clicking on a box for the sensors, you access the automatic / manual operating
mode for specifying sensor values.
Figure 3-5 HMI overview screen of tunnel
S7-1500R/H redundant system
Getting Started, 10/2018, A5E44910930-AA
Programming
41