Cisco PowerVu D9858 Installation And Operation Manual page 77

Setup Menu: Admin,
CDT#
Description:
Parameters:
Recv
Description:
Parameters:
Reject
Description:
Parameters:
Command
Description:
Parameters:
Date Format, Time Format
Description:
Parameters:
D9858 Menu
Description:
4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Continued
Indicates the total number of expected CDTs, the number received,
the number rejected and the download command.
This is the number of tables expected to be received during the
current download operation.
This is the number of CDTs received since the last completed or
aborted download, or power-cycle.
Read-only numeric value.
This is the rejected table count. Tables are rejected whenever
validation fails due to things like CRC failure or incorrect code or
transcoder type.
Read-only numeric value.
Indicates the download command.
Restart, Abort or None. Abort stops a download that is currently
being received. Restart restarts a previously aborted download.
Note that the download does not resume from where it was
aborted, but restarts from the beginning. None means no action is to
be performed.
Sets the Date and Time formats and the GMT offset. Time
information is normally broadcast as part of the transmitted digital
signal. It is usually the broadcasters local time relative to GMT
(Greenwich Mean Time).
Date - The following formats are supported: YYYY_MM_DD,
DD_MM_YYY, MM_DD_YYYY, MM_DD, INVALID.
Time - The following formats are supported: 24Hr, 24Hr
SuspendZero the (leading zero is dropped from the time), 12Hr,
12Hr SuspendZero (the leading zero is dropped from the time).
GMT Off - Time is displayed using a time zone instead of the true
local time. If the current broadcast time is not your local time, you
must change this time setting in the range from -12.0 to +12.0 hours
in 0.5 hour increments.
Sets whether to display the onscreen banner message after booting
up the transcoder.
4-25