Siemens SIMATIC MV500 Operating Manual page 129

Scanner portal
In this group, you can define whether the reader is to take over the function of the master
reader.
Table 6- 24 Scanner portal
Parameter Possible values
Master reader ☐ / ☑
Verification
In this group, you can make the settings for the quality classes and verification details.
Table 6- 25 Verification
Parameter Possible values
Code quality clas-
•
ses
•
Verification details
•
•
Note
Assignment of the code quality classes
For information on assigning the code quality classes to the quality evaluation "Good", "Fair",
and "Poor", refer to "Settings > Options > Extras".
The "A, B, C, D, F" representation is available for reasons of compatibility. The "4, 3, 2, 1, 0"
representation is normal. The selected representation has no influence whatsoever on the
result of the verification.
SIMATIC MV500
Operating Manual, 05/2019, C79000-G8976-C495-02
Default
☐
Default
4,3,2,1,0
4,3,2,1,0
A,B,C,D,F
On
On
Off
Description
Specifies whether this reader should take over the
function of the master reader in a scanner portal
application.
Communication with the higher-level system (e.g.
controller) is performed via the master reader.
Description
You set the type of representation of the quality
grades you prefer. The setting relates both to the
display in the WBM as well as to output via the
interfaces.
Only for data matrix verification:
On: Verification details such as cell position and
grid lines are calculated and can be displayed.
Off: No details for displaying the verification result
are calculated. This details cannot be displayed.
Settings
6.2 Options
129