Related Manuals for Redarc G52-BEP
Summary of Contents for Redarc G52-BEP
- Page 1 EGT & Boost Pressure 52mm Gauge (with Optional Oil Pressure Display)* G52-BEP BOOST X100 *Optional Oil Pressure Display requires the purchase of GS-P-150...
-
Page 2: Warning And Safety Instructions
INSTALLED AS PER THESE INSTALLATION INSTRUCTIONS. NOT SUITABLE FOR MARINE APPLICATIONS. The G52-BEP Boost & EGT Gauge is designed to provide an accurate indication of boost pressure & exhaust gas temperature. As accurate as the indication might be, these gauges are not designed to be a substitute for regular maintenance and inspection by a qualified technician. -
Page 3: Installation
* Connect to a dash light that dims via the vehicle dimmer adjustment to ensure the gauge dims accordingly. If your illumination circuit in your vehicle varies the positive voltage for dimming you will require a REDARC Enhanced Lighting Controller (GA-ELC) to get the gauge to dim with your night-time driving lights. -
Page 4: Egt Probe Installation
7. Connect the interface plug wires. (Refer to diagram below) Note: yellow wire should be connected to ‘+’, red wire to ‘-’ REDARC also offer a range of different sized muffler clamp mounts to suit the EGT Probe. Refer to www.redarc.com.au for more details. - Page 5 316 stainless steel, adjustable, 1/8 inch NPT male thread* + = Yellow, - = Red Wiring 23mm 50mm 2000mm 53mm O4.75mm ⁄ th NPT Sensor Location * ¼ NPT Thread Compression fitting and steel bung available to Purchase at www.redarc.com.au...
-
Page 6: Setup Instructions
Setup Mode is only required if you wish to change settings such as background color or other options. Setup mode is indicated by the display of the programming symbol. A detailed listing of the Setup Modes for the G52-BEP can be found on page 6. To enter Setup Mode:... -
Page 7: Setup Modes
OPERATING INSTRUCTIONS Setup Modes (Setup mode is indicated by display of the programming symbol ID Select Mode / Beeps: Selections: 0 to 9 & A to F (16 selections) BOOST For a single gauge setup do not change this selection as only the default selection X100 “Id.0”... - Page 8 RECOMMENDED ACCESSORY: ENHANCED LIGHTING CONTROLLER (GA-ELC) The REDARC Enhanced Lighting Controller is designed to enhance the lighting of your REDARC gauge. It is to be used when you do not have a dimming circuit to connect your gauge to or the dimming circuit in your vehicle does not dim the REDARC gauge to your liking.
-
Page 9: Frequently Asked Questions
You will need to purchase an Enhanced Lighting Controller (GA-ELC). This module is to be used when you do not have a dimming circuit you can connect your gauges to, are using REDARC Gauges for all of your instrumentation so require dimming or the dimming circuit in your vehicle does not dim the REDARC gauges to your liking. -
Page 10: Two Year Product Warranty
• Friendly, personalised, professional service and product support In the unlikely event that a technical issue arises with a Redarc product, customers are encouraged to initially contact the Redarc Technical Support Team on (08) 8322 4848 power@redarc.com.au for prompt and efficient diagnosis and product support.
Need help?
Do you have a question about the G52-BEP and is the answer not in the manual?
Questions and answers