Exergen TemporalScanner TAT-2000 Series Manual page 10

Smart Glow Features
Soft Glow Display: Soft lighting for easy reading in any light. Perfect for checking
the temperature of a sleeping infant (or adult) in a darkened room.
8 Temperature Memory: Automatically retains the last 8 temperature readings for
instant recall to check on fever progression.
Programmable °F or °C: Select most convenient temperature scale.
Programmable Beeper: Beeping sound indicating scanning can be turned off or
on to avoid waking a sleeping child (or adult). The flashing LED facing the forehead
while scanning turns off when the beeper is turned off.
One-button Programming: Elegant one-button programming & memory access.
To Use the 8 Temperature Memory Recall Mode
In memory mode, a small "M" will appear on the display with memory location
(1,2,3,4,5,6,7,8) and the memory location will alternate with the temperature stored
in that location. The most recent temperature is stored in location 1 and the earliest
temperature is stored in location 8. A reading of 188.8 means that no temperature
reading is stored in that memory location. Readings already in the memory when you
first use it are from the factory tests.
1. To enter memory recall mode, start from a blank display, and tap the button. 1
2. To access previously stored readings, tap the power button again. 2
3. To exit memory recall mode and take a temperature, press and hold the button for
Programmable Beeper
Your TemporalScanner is equipped with a beeper and front/back flashing LED's which
gives you a soft audible and visual feedback as you scan over the temporal artery on
the forehead. The original factory setting is with the beeper and LED's ON.
If the beeper is on and you are concerned that the sound or flashing LED may wake a
sleeping child (or adult), the beeper and front LED can be turned off as follows:
1. Starting with a blank display, tap the power button until the display flashes
2. Press and hold the button until Shh is displayed, indicating the quiet
3. To turn the beeper and front LED back on, repeat step 1 to find Shh then
10
will appear and alternate with the temperature stored in that memory location.
with the temperature in that memory location. Repeat through 8
recent memory readings.
1-2 seconds until the display turns off.
loud. (tap 10 times, past the 8 memory locations and the F-C display)
mode. A beep will indicate that the setting has been changed, and the
TemporalScanner will automatically shut off.
step 2 to change into loud.
M
will alternate
M
to access all
M