System Set-Up; Realignment - Kenwood NX-411 Service Manual

Merchandise received
License and frequency allocated by FCC
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
Are you using the speaker microphone?
Are you using the voice guide & storage unit?
Delivery
1. Modes
User mode
Panel test mode
PC mode
Firmware
programming mode
Clone mode
Firmware version information

SYSTEM SET-UP

A personal computer, programming interface (KPG-36A/36U),
USB adapter (KCT-53U), and programming software
(KPG-111D: ver. 2.80 or later) are required for programming.
(The frequency, and signaling data are programmed for the transceiver.)
YES
NO
YES
NO
YES
NO

REALIGNMENT

Panel tuning mode
Data programming mode
PC test mode PC tuning mode
Frequency range (MHz) RF power
RX 935~941
TX 896~902 2.5W
935~941
KRA-38
Optional antenna
(Option)
KMC-41/KMC-42W
Speaker microphone
or
KMC-47GPS
GPS speaker microphone
(Option)
VGS-1 See page 6.
(Option)
Mode
User mode For normal use.
Used by the dealer to check the fundamen-
Panel test mode
tal characteristics.
Panel tuning mode Used by the dealer to tune the transceiver.
Used for communication between the trans-
PC mode
ceiver and PC.
Data programming Used to read and write frequency data and
mode other features to and from the transceiver.
Used to check the transceiver using the PC.
PC test mode
This feature is included in the FPU.
Firmware program- Used when changing the main program of
ming mode the fl ash memory.
Used to transfer programming data from one
Clone mode
transceiver to another.
Firmware version
Used to confi rm the internal fi rmware ver-
information sion.
NX-411
Type
NX-411 K2
Function
3