Connection Methods Available For Setup; Changing Between Connection Types - ElectrIQ P12HPW Manual

CONNECTION METHODS AVAILABLE FOR SETUP

The smart devices have two different setup modes, Quick Connection and AP (Access
Point). The quick connection is a quick and simple way to set the unit up. The AP
connection uses a direct local wifi connection between your phone and the air conditioner
to upload the network details.
Before starting the setup, please ensure that your air conditioner is in the correct standby
mode for the connection type you are attempting, the flashing of the wifi light on your air
conditioner will indicate this.
Connection Type
Quick Connection
AP (Access Point)

CHANGING BETWEEN CONNECTION TYPES

To change the unit between the two connection types, hold the Sleep button for 5 seconds.
CONNECTING USING QUICK CONNECTION
Before initiating the connection, make sure the unit is in standby mode, with the light
flashing twice per second. If not follow the guide in the factory reset section, also ensure
your phone is connected to the wifi network.
1. Open app and click "+" to add
device
Frequency of Flashes
Flashes twice per second
Flashes once per three seconds
Page 4 of 11