Terminal Commands - Assa Abloy LCU9101 Manual

LCU9101

Terminal commands

In addition to the configuration guide described above there are a
number of commands that can be used at configuration and
troubleshooting. A complete list over terminal commands that can
be used in ARX ACCESS you find on page 20Fel! Inget
bokmärkesnamn angivet..
The following command can be used in the terminal software to
configure the ARX ACCESS system:
Command
setup
nv set arx <IP-adress>
nv set arx <servernamn>
nv set dns <IP-adress>
nv set domain <domän>
nv set ip <ip-adress>
nv set gateway <gateway-
adress>
nv set hostname <ucnamn>
nv set netmask <nätmask>
nv show
Description
Starts the configuration guide
"LCU Wizard"
States the IP address to the
ARX Server
States another name (DNS) of
the ARX Server (the default
name is *arx*)
States the IP address for a
possible DNS Server
States the domain the control
unit belongs to (ex:
company.com)
States an IP address for the
control unit
States the default gateway
States a name for the control
unit.
States the netting for the
control unit
Shows all variables
23