Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Fransgard Manuals
  4. Winches
  5. V-4000
  6. Manual

Fransgard V-4000 Manual

Farm tractor winch
Hide thumbs

Advertisement

Quick Links

Fransgård
Farm tractor winch
Manual
GB
V-4000
V-6500

Advertisement

loading
Need help?

Need help?

Do you have a question about the V-4000 and is the answer not in the manual?

Questions and answers

Dai
January 22, 2025

is it ok to put a drop of oil on the 2 small rods that activate the clutch as it is not releasing ?

0
Brent McCloskey
February 28, 2025

Is there touch up paint available?!

0

Related Manuals for Fransgard V-4000

Summary of Contents for Fransgard V-4000

  • Page 1 Fransgård Manual V-4000 Farm tractor winch V-6500...
  • Page 2 Fransgård Maskinfabrik A/S Fredbjergvej 132 DK - 9640 Farsø Telefon : +45 98 63 21 22 : +45 98 63 18 65 www.fransgard.dk E-mail : info@fransgard.dk...

  • Page 3: Table Of Contents

    Instructions for use ....................2 Danger / warning ....................3 Adjusting the clutch ....................4 Instructions for mounting the wire ................ 6 TECHNICAL SPECIFICATIONS V-4000 Pulling power ................4000 kg / 8800 lbs. Clutch ....................... 385 cm². Transmission ................5/8" roller chain.

  • Page 4: Safety Instructions

    SAFETY INSTRUCTIONS LUBRICATION AND MAINTENENCE The machines may only be used by qualified Lubricate the PTO shaft once daily. operators. Lubricate the chain once every week. Before starting working, check that the tractor No oil on clutch lining (15509). and the machines are standing on a fixed The turning plate at the top pulley has to be horizontal base.

  • Page 5: Danger / Warning

    DANGER! Read before operation this machine! It is the owner’s responsibility to instruct all equipment operators and support personnel in the operation of winch. WARNING! Do not attempt to operate this winch without proper training. Do not operate this machine until the owner’s manual has been completely read and understood.

  • Page 6: Adjusting The Clutch

    ADJUSTING THE CLUTCH The clutch is adjusted at the factory. If it is necessary to adjust it do so as follows: 1. Loosen lock nut no. 53 and bolt no. 54. 2. Hold lever no. 20 against stop, tighten both bolts no. 54 until slight resistance is felt. 3.
  • Page 7 Clutch Adjustment for Fransgård forestry winches. Basic adjustment – after changing lining, chain wheel and main shaft Make sure the large 1” lock nut (Nut Nut C C) is tightened and will not move on the main shaft when a load is applied on the winch.
  • Page 8 V-4000...
  • Page 9 V-6500...

  • Page 10: Instructions For Mounting The Wire

    Instructions for mounting the wire. 1.) Pull about 1 metre of the wire 1 out through hole 2 and back through hole 3 and out through hole 4. 2.) Mount the wire fixing block 5 (making sure that only 5 mm of the wire are introduced into the fixing block) and fasten with the allen screw and the unbraco wrench supplied.

This manual is also suitable for:

V-6500
Save PDF