Configure Network And; Figure 3.8 Network And Web Configuration Screen; Table 3.1 Network And Web Configuration Fields - Chatsworth Products 60106-001 User Manual

3.3 Configure Network and Web Properties
Use the Configuration section of the Protocol Converter's web interface to configure basic device functionality. The Network
and Web link displays the MAC address and allows you to fill in the IP Address, Net Mask, Default Router (Default Gateway),
Passwords, and Refresh rate.
In the user interface, go to Configuration>Network and Web. Edit the fields appropriately.
Option
IP Address
Net (Subnet)
Mask
Def (Default)
Route
Web
Password
Read Only
Chatsworth Products, Inc. (CPI) • 800-834-4969
Figure 3.8 Network and Web Configuration Screen
Description
The Protocol Converter is configured at the factory with a default IP
Address of 10.0.0.188. If you'd like to change the IP address, do so here.
Default: 10.0.0.188
The Protocol Converter is configured at the factory with a default Subnet
Mask of 255.255.255.0. Edit this field as necessary.
Default: 255.255.255.0
The Protocol Converter is configured at the factory with a default Gateway
Route of 10.0.0.1. Edit this field as directed by your IT department.
Default: 10.0.0.1
The Protocol Converter can be configured with two passwords - the read
only password allows users to access the web interface but not to edit any
of the configurable settings.
Specify an alphanumeric value up to 16 characters.
Table 3.1 Network and Web Configuration Fields
RIM-Protocol Converter User Guide - Version 1.0
25