Page 1
π H-5221 1-800-295-5510 uline.com TABLETOP PATIO HEATER DESCRIPTION QTY. Reflector Emitter Wire Guard Access Door (Preassembled to Heater Housing) Base Ring Weight Post with Burner Assembly Heater Housing DANGER! FOR YOUR SAFETY. WARNING! For outdoor use only. If you smell gas: DANGER! CARBON MONOXIDE HAZARD.
Page 2
SAFETY Please read and understand this entire manual before DANGER! CARBON MONOXIDE HAZARD. attempting to assemble, operate or install the product. • This heater is a combustion appliance. All combustion appliances produce carbon This manual contains important information about the monoxide (CO) during the combustion assembly, operation and maintenance of this patio process.
Page 3
SAFETY CONTINUED WARNING! CALIFORNIA PROPOSITION 65. CAUTION! SERVICE SAFETY. Combustion byproducts of this product contain • Keep all connections and fittings clean. Make chemicals known to the state of California sure propane cylinder valve outlet is clean. to cause cancer, birth defects and other •...
TOOL REQUIRED Phillips Screwdriver (not included) PARTS Nut x 3 Wrench x 1 3/16" Stainless Cap Nut Washer Steel Screw 20mm Bolt Reflector Spacer ASSEMBLY 1. Attach post with 3. Put three reflector Figure 3 Figure 1 burner assembly spacers into the onto heater housing holes in the emitter.
Page 5
ASSEMBLY CONTINUED 5. Put washers in the 6. Rotate regulator Figure 5 Figure 6 top of support preassembled to bolts on post with post with burner burner assembly. assembly toward Attach reflector to opening in heater assembly with cap housing. Line up nuts and washers.
OPERATION PORTABLE HEATER LOCATION DANGER! CARBON MONOXIDE HAZARD. For outdoor use only. Never use inside house, 1. This portable heater is intended for outdoor use only. or other unventilated or enclosed areas. This Always ensure adequate fresh air ventilation. heater consumes air (oxygen). Do not use in unventilated or enclosed areas to avoid 2.
OPERATION CONTINUED knob, press the igniter button several times until the 5. After the flame comes on, leave the variable control pilot flame comes on. After lighting the pilot, wait 15 knob on LO for about five minutes, and then switch seconds to heat the thermocouple, before releasing to the desired temperature.
TROUBLESHOOTING OPERATING ISSUE CAUSES RECOMMENDATIONS Pilot won't light. 1. Cylinder valve is closed. 1. Open valve. NOTE: Heater operates at 2. Blockage in orifice or pilot tube. 2. Clean or replace orifice or pilot tube. reduced efficiency below 3. Air in gas line. 3.
Need help?
Do you have a question about the H-5221 and is the answer not in the manual?
Questions and answers