Setting Test Mode; Shutter Release And Exposure; Af Function - Pentax ist DL Service Manual

(5) Disconnect the video cable and the AC adapter from the camera
when POWER OFF is displayed.

14-4. Setting Test mode

*With this setting, camera can operate even without SD card cover.
(If [11.Shutter speed adjustment] was executed, you can skip this section)
(1) Insert SD card for Test mode ON to the camera.
(2) Connect AC adaptor to the camera. (LCD will be displayed moment)
(3) Remove SD card from the camera.
(4) Display will be appeared on the LCD when press shutter button
half way.
14-5. Shutter release, exposure
Please check the following function
(1) Shutter release function works properly.
(2) Diaphragm setting lever move up-side down when set the Main SW change to Preview mode
(3) The information of Tv and must be changed when the e- dial is turned
(4) Set TV [ 1 ], and then check if shutter open fully
(5) Attach a lens to the camera and set the AF_SW to MF position (up position) and set aperture
to A position.
(6) The information of Tv and Av must be displayed in the viewfinder and on the LCD panel when
the release button is depressed halfway.
(7) The information of AV must be changed when turn the e- dial while pressing the AV button
(8) The aperture of lens must change similarly when the aperture value (Av) is set in opening, the
middle, and the minimum with the Av dial.
*When replacing T100, the aperture of middle will not control until adjusting with
Programmed Software. (SLR operation)

14-6. AF function

(1) Set lens (A position) to the camera and set the AF_SW to AF (down position).
(2) The distance ring of the lens must turn between infinity (∞) and shortest distance end when
the shutter button is depressed halfway while covering the front of lens with the palm.
(3) Confirm the operation of AF while depressing the shutter button halfway.
(4) Disconnect AC adaptor and lens from the camera
14-7. Reset Test mode
[Caution] When the function check is finished, reset the test mode as following.
(1) Insert SD card for Test mode OFF into the camera.
76570EM 35
PENTAX *IST DS
UPDATING DSP FIRMWARE
SECTOR** >> PROGRAM
PENTAX *IST DS
_____________
UPDATING DSP FIRMWARE
NEVER POWER OFF
････ COMPLETE ････
VERSION 1.00.00.10
POWER OFF