SCANGRIP Sun Operating Instructions Manual page 2

Product Description
• Rechargeable Ultra High Power LED Work Light.
• Waterproof and shock proof for use in all kinds of complex environment.
• Advanced high power LED binding technology with a lifespan up to 100,000 hours.
• Patented induction charging design. Eradicates charging problems caused by short circuits, oxidation, dirty con-
tacts etc.
• Intelligent circuit design with brightness adjustment, overcurrent, overvoltage, overcharge and overdischarge pro-
tection.
• Projects a warm white and very intense light.
• Illumination is more than three times brighter than traditional LED inspection lights.
• Illuminates an area four times wider than traditional LED inspection lights by diffusing the light in an 80° arc.
Specifications
Article no.:
Operating time (main light):
Operating time (spot light):
Charging time:
Battery charger operating voltage:
Battery specification:
LED intensity @ 50cm (main light):
LED intensity @ 50cm (spot light):
Operating temperature range:
Ingress Protection:
Dimensions – work light (D x L):
Dimensions – charging base (H x W x D):
Weight – work light:
Weight – charging base:
Warning
Working safely with this lamp is possible only when the operating and safety information
are read completely and the instructions contained therein are strictly followed.
• Avoid looking directly into the beam, as it will dazzle.
• Don't use the lamp near open flames.
• In order to extend the battery lifespan, don't overdischarge the battery.
• If lamp will be stored for one month or more, please fully charge it prior to storage.
• Replace battery with same standard.
Battery Treatment / Charging Instruction
• Charge the battery for more than 10 hours before first use
• Recharge the battery when main LEDs blink.
• Red indicator will turn on while battery is flat. At this stage please recharge to protect the battery.
• Red indicator on: charging
• Red indicator off: charging completed
• Don't leave battery flat. Otherwise it could be overdischarged and may NOT be able to be reused.
• When you don't use the work light for a long time, recharge in every 30 days.
• When you put the lamp into the charger and the red indicator begins to blink, it means the charger is reactivating
the batteries. This process would take around 0.5 to 3 hours and then the indicator turns into constant red for nor-
mal charging.
• If the red indicator still blinks after 3 hours, please unplug and try again.
• If the battery still can't be recharged normally, replace the battery.
SUN
03.5002
Up to 3 hours
Up to 8-10 hours
3 - 4 hours
230V AC / 50Hz
3.7V / 2400 mAh Li-Polymer
500 lux
1200 lux
-10 to +40°C
IP68
Ø55 x 280 mm
107 x 95 x 110 mm
0.32 kg
0.22 kg