Registering The Repeater - Yealink RT30 User Manual

Star setup:
Up to 6 repeaters can be registered to one base station to extend the range
in a star layout. All repeaters must be installed within the base station
coverage, as shown in the figure below.

Registering the Repeater

Registration
If you want to register more than one repeater, in order to avoid ID conflict,
we recommend that you put the repeaters closer to the base station and
register the repeaters one by one.
1. Plug the repeater into an AC outlet.
POWER LED turns green and DECT LED flashes red.
2. Set the handset in RT30 repeater mode at the path: Settings->System
Settings->Repeater Mode.
3. Set the base station in registration mode (Long press the paging key on
the base station till the first LED flashes green).
If base station is found, DECT LED will flash orange.
When DECT LED turns green/orange, the registration to base station is
successful.
Cascade Registration
Up to 2 repeaters can be registered to the base station in a cascade setup.
4
RT30
50m/300m
RT30
W60B
RT30
RT30
RT30
RT30
www.yealink.com