Advertisement
1. Level of gain; low, medium and high speed
2. Current speed
3. Run; ODO total mileage / TRIP single run
4. Mileage
5. Charge level of 4 blocks - 100-80% of charge; 3 blocks
- 80-60% of charge; 2 blocks - 60-40% of charge; 1 unit -
40-20% of charge; 0 units - 20-0% of charge
6. Switch Gears
7. Gain -: Turn on: short press to decrease gain
8. Error Code: Hall sensor fault (1), switching of speeds
fault (2) failure of the electric motor (3) protection of
low pressure (4), protection against electric overload
Driving of the Bicycle
Press and hold the power button (more than
2 seconds), the system will give power then
strengthening is possible.
When driving, keep the velocity faster than
4.2 km / h (usually this speed is reached
after passage of two circles). Using the
control panel (which is located on the right
side), you can adjust the ride only by an
electric motor, in which case you can not
pedal. Turn off power of brake and gears,
then switch to gain.
Measuring panel has an USB port to charge
your phone (5V / 1A).
If after bike C1 be at rest for 20 minutes, it
automatically turns off.
During braking better use the left rear brake
handle;
Please choose roads, that are banned from
entering self-propelled vehicles;
Timely check the battery level since riding,
low charge could affect the lifespan of the
battery.
Use battery according to the conditions
described in the instructions;
When driving on long distances, you need
to contact the pro shop to check the spokes
and screws.
(5), protection from blocking messages (6), problems
powered brake system (7), failure data (8). If you find
faults displayed wink appropriate designation
9. Gain + / Rear lights: Turn on: short press to increase
the gain; long press to turn on backlight, repeated long
press to turn off backlight
10. Bluetooth icon: when Bluetooth is connected,
appropriate designation lits
11.USB icon: when connected to the USB port, the
display shows the USB icon designation
Advertisement
