Programming The Cd Tracks - Sony CDP-XE570 Operating Instructions Manual

Programming the CD
tracks
You can arrange the order of the tracks on a
disc and create your own programme. The
programme can contain up to 24 tracks.
1
Press PLAY MODE repeatedly until
"PROGRAM" appears in the display
before you start playing.
2
Turn lAMSL until the track you
want appears and push lAMSL to
select the track.
The track number that you programmed, the
playing order, and the total playing time
appear in the display.
If you've made a mistake
Press CLEAR, then repeat Step 2.
Tip (CDP-XE570/XE370 only)
You can select the track using the number buttons
on the remote. To select a track with a number
over 10, use >10 (see page 9).
3
Repeat Step 2 to programme the tracks
in the order you want.
4
Press H to start Programme Play.
To cancel Programme Play
Press PLAY MODE.
Tips
• The programme remains until erased or until you
press AOPEN/CLOSE. The programme you have
created remains even after the Programme Play
mode ends or you select another play mode.
• For the recording to the A side or B side of the
cassette tape, you can pause Programme Play.
Notes
• The total playing time doesn't appear in the
display when it exceeds 100 minutes.
• If you programme a track numbered over 24 (or 68
for the CDP-XE370/XE270), "– – . – –" appears
instead of the total playing time.
• "PROGRAM FULL" (or "FULL" for the CDP-
XE370/XE270) appears in the display when you
try to add a track to a programme which already
contains 24 tracks.
12
Checking the track order
(CDP-XE570/XE370 only)
You can check your programme before or after
you start playing.
Press CHECK.
Each time you press this button, the display
shows the track number in the programmed
order. After the last track in the programme, the
display shows "- END -" (or "End" for CDP-
XE370) and returns to the original display. If
you check the order after you start playing, the
display shows only the remaining track
numbers.
Changing the track order
You can change your programme before you
start playing.
To
You need to
Erase a track
Press CHECK until the track you
don't want appears in the display,
then press CLEAR (CDP-XE570/
XE370 only).
Erase the last track
Press CLEAR. Each time you
in the programme
press the button, the last track will
be cleared.
Add tracks to the
Turn lAMSL until the
end of the
track number you want to add
programme
appears, then push
lAMSL.
When using the remote, press the
number buttons of the tracks to be
added (CDP -XE570/XE370
only).
Change the whole
Hold down CLEAR until
programme
"CLEAR" (for the CDP-XE570)
completely
or "CLEAr" (for the CDP-XE370/
XE270) appears in the display.
Create a new programme
following the programming
procedure.