Troubleshooting - Craftwell CUT’N’BOSS User Manual

TROUBLESHOOTING

If the machine does not turn on, check that the power cord is securely
connected to the power adapter and that the adapter light is on.
To remove jammed platforms, press and hold the power button until
the reverse feature engages and the platforms are released.
If the emboss or cut is not deep enough, try adding a shim.
To minimize warping of platforms, periodically rotate and turn the platforms over.
If the platforms are rejected from the device, check if too much material
has been placed for cutting or embossing.
If the material has not been cut properly, check that the cutting die
has not been damaged.
CAUTION
Only clean the Cut'n'Boss with a soft, dry cloth. Do not use abrasive cleaners,
spray cleaners, or chemical cleaners on the machine.
Do not allow children to operate the Cut'n'Boss machine unsupervised.
Do not remove platforms until the motor has automatically shut off.
Keep hands away from platforms & parts in motion.
Do not leave objects inside the Cut'n'Boss machine when not in use.
Do not disable the safety sensors to override the motor control.
Forcing platforms & materials through the Cut'n'Boss will cause damage to
your machine and may void the warranty.
Do not use the Cut'n'Boss for 60 minutes of continuous use without
proper cool down.
Allow the Cut'n'Boss to cool down for 15 minutes before re-using.
The Cut'n'Boss is designed for home and recreation use.
Always power off you machine when not in use.