Checking The Fluid Level In The "Front Lift" Hydraulic System - Ferrari 458 Italia Technical Documentation Manual

"Front Lift" ramp clearing front suspension lift (optional)
Turn the ignition switch on.
Wait at least 10 seconds.
Connect the DEIS diagnostic tester to the diagnostic socket (
Start the "NSV bleeding" cycle, using the DEIS diagnostic tester and following the relative instructions.
Wait at least 5 seconds.
Check the fluid level in the "Front Lift" hydraulic system (
Refit the engine compartment cosmetic shields (
Refit the right hand cosmetic shield.

Checking the fluid level in the "Front Lift" hydraulic system

Remove the engine compartment cosmetic shields (
Remove the right hand cosmetic shield.
F2.10).
Remove the protector cap on both shock absorbers
and loosen the indicated bleed unions.
Connect suitable lengths of transparent pipe to the
bleed unions on both shock absorbers.
Immerse the end of the pipes in a container filled
with the hydraulic fluid specified for use in the
system.
Wait for the "NSV bleeding" cycle to complete.
Disconnect the lengths of transparent pipe from the
bleed unions on both shock absorbers.
Tighten the indicated bleed unions and refit the
protector caps on both shock absorbers.
Tightening torque
Union
D4.08).
E3.13).
E3.13).
Page 9 of 10
Nm Class
10 Nm B