Table of Contents
Advertisement
Chapter 3 Fujitsu 3.2 TB Flash Accelerator Card Settings
3.3 Checking Various Information on the Fujitsu 3.2 TB Flash Accelerator Card
6 unassigned
8
reserved
To align the first sector of the partition on a 4 KB boundary, use the format –e command to change the first
sector to an appropriate value.
Note - "256" is the setting at shipment. There is no need to change it.
By setting the first sector value to 256 or a value for aligning on a 128 KB boundary, you can ensure an
alignment for a maximum block size of 128 KB.
3.3
Checking Various Information on the Fujitsu 3.2
TB Flash Accelerator Card
You can check various information on the Fujitsu 3.2 TB Flash Accelerator Card with the nvmeadm
command.
Checking the firmware version
■
# nvmeadm list -v
SUNW-NVME-1
PCI Vendor ID:
Serial Number:
Model Number:
Firmware Revision:
Number of Namespaces:
Checking SMART information
■
# nvmeadm getlog -h
SUNW-NVME-1
SMART/Health Information:
Critical Warning: 0
Temperature: 313 Kelvin
Available Spare: 100 percent
Available Spare Threshold: 10 percent
Percentage Used: 0 percent
Data Unit Read: 0x3d81f38 of 512k bytes.
Data Unit Written: 0x422bdab of 512k bytes.
Number of Host Read Commands: 0xf045bca
Number of Host Write Commands: 0x1027b4eb
Controller Busy Time in Minutes: 0x354
Number of Power Cycle: 0x2
Number of Power On Hours: 0x1c
Number of Unsafe Shutdown: 0x0
wm
wm
6251217551
0
0
8.00MB
0x144d
S3GYNA0JA02542
SAMSUNG MZPLL3T2HMLS-00003
GPNA5B3Q
32
7
0
6251233934
C120-0067-02EN
Advertisement
Table of Contents
