Setup Instructions - Baby Brezza Formula Pro Advanced Instructions For Set-Up, Use And Cleaning

Set-up instructions
Set-up and cleaning videos available at elfe.com.
1
After hand washing these parts, make sure
they are all completely dry before assembly.
3
Place the axle on the base as shown.
2
Assemble the funnel & funnel cover.
Then Insert funnel assembly into funnel
compartment by sliding it up, then in.
4
Now place the powder container on the base
with the printed markings facing you.
5
Set-up instructions continued
5
Place the measuring wheel into the powder
container, tting it over the axle with the at
side facing down.
Make sure the holes in the measuring wheel
are in the same position as shown above.
7
Make sure the locking cover & measuring wheel
look like this when assembled.
Now you're ready to add powder and make your rst bottle.
2
1
6
IMPORTANT
1. Place the front edge of locking cover
in the recess in the inside/front of the
powder container, UNDER THE TAB.
2. Fit hole in locking cover over top of axle.
It will not lay completely at.
8
Now place the stirring wheel on the axle
and push down rmly until you hear a click.
Make sure the stirring wheel is snapped in
place and does not lift up easily.
6