Setting Other Data
Note
*: It is possible to assign the IP Gateway ports to different trunk groups with distinct Hunt
Patterns. In this way, you can handle the incoming calls differently on port-by-port basis.
However, for simplicity, the example above provides the general setting that involves only
1 trunk group and 1 Hunt Pattern for both IP Gateway Ports.
To configure the following parameters, refer to "4.9.1 Configure Gateway Units (KX-TDA0480)"
in the VoIP Gateway Card Installation Manual.
•
Numbering
•
Numbering 2
•
Numbering 3
•
Gatekeeper
•
FAX related
•
Voice mode
•
Network
•
Call Control
•
SNMP
•
DNS
•
Recovery delay
•
Notify e-mail
•
Priority routing information
8.
a.
Click the "Other" tab.
b.
Under "A-law/m-law flag", click "A-law"
or "m-law" depending on the setting of
the Hybrid IP-PBX.
c.
Click [OK].
9. Repeat steps 1 to 8 for all other units in the
network.
3.4 Configuring Office Data
Getting Started
31