Advertisement
Table of Contents
- 1 Introduction
- 2 Key Features
- 3 Interface & Wiring Overview
- 4 Installation
- 5 Configuration & Programming
- 6 PC Application Mode
- 7 Manual Programming Mode
- 8 Radio Dipswitch Settings
- 9 Manually Mapping the Steering Wheel Buttons
- 10 SWC Button Re-Assignment Procedure
- 11 For Short Press Functionality
- 12 For Long Press Functionality
- Download this manual
Advertisement
Table of Contents
Summary of Contents for Autoleads ControlPRO CP2-UNI
- Page 1 CP2-UNI Steering Wheel Control Interface User Manual...
-
Page 2: Key Features
Introduction The Autoleads ControlPro CP2-UNI is a universal interface that allows retention of steering wheel controls, and retained accessory power whenever replacing a factory radio. Use of this interface also allows you to program two radio functions to each steering wheel control button by using short press/long press dual command functionality. - Page 3 SWC Output - Alpine, JVC, Clarion, 3.5mm Jack Pioneer, Sony, Boyo, Dual, Advent, Lightning Audio or Visteon Installation www.autoleads.co.uk/controlpro Please visit to download the PC application or phone app that provides vehicle specific wiring and vehicle dipswitch configurations Configuration & Programming This is the fastest and most convenient way to program the module.
- Page 4 Manual Configuration Mode (continued) With this method, the Autoleads CP2 uses a pre-determined dipswitch configuration to assign the vehicle and steering control button functionality. The dipswitches on the side of the interface must be manually set to the proper vehicle configuration by the user.
- Page 5 The radio dipswitches must be set to the correct radio configuration. www.autoleads.co.uk/XXXXXX 1. Visit to download the Autoleads ControlPro PC application. 2. Launch the application and find the installation instructions for your vehicle 3. Set the radio dipswitches according to the chart on the next page 4.
- Page 6 If you are using the CP2 in manual configuration mode (specific vehicle dipswitch settings) and wish to re-assign button functions, please follow the “Steering Wheel Button Re-Assignment” section Please read each of the following steps to familiarise yourself with the process before beginning. email - technical.eu@aampglobal.com www.autoleads.co.uk...
- Page 7 The LED will flash green 3 times indicating the end of programming. Test the interface for proper functionality. Whenever a SWC button is pressed the LED on the interface should blink green. If any function does not work, repeat the programming steps email - technical.eu@aampglobal.com www.autoleads.co.uk...
- Page 8 - technical.eu@aampglobal.com www.autoleads.co.uk...
- Page 9 If you come across a function in the chart that your steering wheel does not have, or you do not want to program, press and release the program button on the side of the interface to skip that function. The LED email - technical.eu@aampglobal.com www.autoleads.co.uk...
- Page 10 - technical.eu@aampglobal.com www.autoleads.co.uk Autoleads is a Power brand of AAMP Global.
Need help?
Do you have a question about the ControlPRO CP2-UNI and is the answer not in the manual?
Questions and answers