Sony HANDYCAM DCR-SR40 Handbook page 62

CAMERA DATA
Movie
Still image
3SteadyShot off
4Exposure
5White balance
6Gain
7Shutter speed
8Aperture value
9Exposure value
• appears for an image recorded using a flash
(optional).
• The data code is displayed on the TV screen, if
you connect your camcorder to a TV.
• The indicator toggles through the following
sequences as you press DATA CODE on the
Remote Commander: DATE/TIME t
CAMERA DATA t OFF (no indication) (DCR-
SR60/SR80).
• Depending on the hard disk condition of the
camcorder, bars [--:--:--] appear.
• The setting returns to [OFF] after you remove the
power source for more than five minutes.
DISPLAY
You can select the number of thumbnails that
appear on the VISUAL INDEX screen.
Thumbnail 1 Glossary (p.124)
B ZOOM LINK
Change the number of thumbnails (6 or 12)
with the zoom lever on your camcorder.*
6IMAGES
Displays thumbnails of 6 images.
12IMAGES
Displays thumbnails of 12 images.
62
00:00:00
60min
AWB
60min 10/10
* You can operate with the zoom buttons on the
LCD frame or on the Remote Commander
(DCR-SR60/SR80).
REMAINING
B AUTO
Displays the remaining hard disk free space
for about eight seconds as described below.
– When your camcorder recognizes the free
hard disk space, with the POWER switch
is set to (Movie)
– When you press DISP/BATT INFO to
switch the screen display from off to on,
with the POWER switch is set to
(Movie)
– When you start recording from the line
input (DCR-SR60/SR80)
ON
Always displays the remaining hard disk
free space indicator.
• When the available free space on the hard disk of
the camcorder becomes less than five minutes for
movie recording, the remaining free space will be
displayed all the time.
REMOTE CTRL (Remote control)
(DCR-SR60/SR80)
The default setting is [ON] so that you can
use the supplied Remote Commander (p.41).
• Set to [OFF] to prevent your camcorder from
responding to a command sent by other device's
remote control.
• The setting returns to [ON] after you remove the
power source for more than five minutes.
REC LAMP (Recording lamp)
(DCR-SR60/SR80)
The camera recording lamp will not light up
during recording when you set this to [OFF].
(The default setting is [ON].)