Stahl 9182 Series Operating Instructions Manual page 36

Technical Data
EN
Technical Data
EN
Version
EN
EN Limiting values
Message
EN
EN
Switching voltage
EN
Switching current
(resistive load)
EN
Switch on
EN
resistance
EN
Reclosing lockout
EN
Version
Error detection
EN
Ex i input
EN
Open circuit
EN
Short-circuit
EN
EN
Behaviour of the
EN
output
Settings
EN
(switch LF)
EN
Error detection
EN
Message of line
fault and auxiliary
EN
power failure
EN
Electromagnetic
compatibility
EN
EN
Ambient conditions
EN
Ambient temperature
Single device
Group assembly
Storage temperature -40 to +80 °C
Relative humidity
(no condensation)
Use at the height of
Electrical connection
Connection diagram
12
Temperature transmitter Ex i
Series 9182
9182/.0-50-12 with limit contact, 9182/10-51-12 and
9182/10-51-14, SIL 2
2 NO / NC
(configurable using ISpac Wizard)
( ±30 V
( 100 mA
( 2.5 O (typical < 1 O)
Reset using the DIP switch or "Power-Off" (configurable)
for all types 9182/.0-5.-1.
for resistance thermometers, thermocouples and resistance transmitters
> 1 kO
for resistance thermometers with temperature linearisation and resistance
transmitters
2.4 mA (configurable 0 to 23 mA or "hold last value")
activated / deactivated (only 9182/.0-51-11, 9182/10-59-11, 9182/10-51-12,
9182/10-51-14, 9182/.0-50-12)
LED red "LF"
- contact (30 V / 100 mA) closed to earth in case of error
- pac-Bus, potential-free contact (30 V / 100 mA)
Tested under the following standards and regulations:
EN 61326-1 Use in industrial environment;
NAMUR NE 21
-20 to +70 °C
-20 to +60 °C
The installation conditions affect the ambient temperature.
Observe the "Cabinet installation guide"
( 95 %
< 2000 m
See labelling on the device
160562 / 9182601310
2018-03-21·BA00·III·en·17