System Set-Up; Realignment - Kenwood NX-200 Service Manual

Merchandise received
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
NO
Are you using the speaker microphone?
NO
Are you using the voice guide & storage unit?
NO
Delivery
1. Modes
User mode
Panel test mode
PC mode
Firmware
programming mode
Clone mode
Firmware version information

SYSTEM SET-UP

Frequency range (MHz) RF power
A personal computer, programming interface (KPG-36A/36U),
and programming software (KPG-111D)
are required for programming.
(The frequency, and signaling data are programmed for the transceiver.)
YES
Are you using the GPS function?
YES
KMC-41/KMC-42W/KMC-51/KMC-52
YES

REALIGNMENT

Panel tuning mode
Data programming mode
PC test mode PC tuning mode
TX/RX 136~174 5W
TX/RX 136~174 5W
NO
KRA-22/KRA-26
Optional antenna
(Option)
Speaker microphone
(Option)
VGS-1 See page 7.
(Option)
Mode
User mode For normal use.
Used by the dealer to check the fundamen-
Panel test mode
tal characteristics.
Panel tuning mode Used by the dealer to tune the transceiver.
Used for communication between the trans-
PC mode
ceiver and PC.
Data programming Used to read and write frequency data and
mode other features to and from the transceiver.
Used to check the transceiver using the PC.
PC test mode This feature is included in the FPU.
See pages 45 to 57.
Firmware program- Used when changing the main program of
ming mode the fl ash memory.
Used to transfer programming data from one
Clone mode
transceiver to another.
Firmware version Used to confi rm the internal fi rmware ver-
information sion.
NX-200(G)
Type DTMF keypad
NX-200(G) K No
NX-200(G) K2 Yes
YES
KRA-43G
Optional antenna
(Option)
Function
3