Contractor And 1 Day Codes; How To Release The Shackle - Sentrilock REALTOR NXT Series Owner's Manual

blinking, you will not be able to access the Key Vault for some time. For more
information about the lights on the lockbox, see "Getting to Know Your REALTOR®
Lockbox" on page 24.
4. To close the lockbox Key Vault, make sure the dwelling key is laying flat in the "cupped"
area of the key door and swing the Key Vault door up. Using both thumbs, press firmly
on the top left and top right comers of the key door until it won't push in any more.

Contractor and 1 Day Codes

You can use a contractor or 1 day code to open the Key Vault of a lockbox without a SentriCard®. This is
useful for Contractors, Appraisers or other trades people who need access to a listing's key, but do not have a
SentriCard®.
To use a contractor or 1 day code, press the ENT key on the keypad of a lockbox. This will wake up the
lockbox. Next, enter the contractor or 1 day code and press ENT. The lockbox will open the Key Vault.
Note: before you can use a contractor code, the owner of the lockbox must turn on contractor mode. To turn
on contractor mode, the lockbox owner can enter FUNC + 6 +1 + ENT on the keypad of a lockbox. Before you
can use a 1 day code, the owner of the lockbox must do one of two things. They can turn on contractor mode;
or enable 1 day codes. For more information about how to enable and generate 1 day codes, see "1 Day
Codes" on page 51.
You can find your contractor codes on your Card Carrier sheet or the Agent Default Lockbox Settings
window.
Note: if you have a lockbox that is not responding to a SentriCard®, but the keypad lights up when you press a
key, you may be able to use a contractor code or 1 day code to access the Key Vault and remove the key.

How to Release the Shackle

After you've taken ownership of your REALTOR® Lockbox, you may begin using your lockbox. When you are
ready to attach or remove your lockbox, you need to remove the shackle. The following information will guide
you through removing the shackle from a lockbox.
Note: if an Agent has not taken ownership of a lockbox, you can release the shackle without a SentriCard®.
Press FUNC + 1 + ENT to release the shackle.
1. Insert your SentriCard® into your lockbox. Wait for the lockbox to display the CODE
light, then enter your PIN and press ENT. Do not remove your SentriCard® from the
lockbox.
2. When the lockbox displays the READY light, press FUNC +1 + ENT. The lockbox will
begin beeping.
3. While firmly holding the lockbox, gently press the shackle into the lockbox as the lockbox
The REALTOR® Lockbox Owner's Guide
The REALTOR® Lockbox
Owner's Guide •
34