Step 2: Charging The Battery Pack - Sony DCR-HC30/HC40 Operation Manual

Step 2: Charging the
battery pack
You can charge the battery by attaching the
"InfoLITHIUM" battery pack (P series) to
your camcorder.
b Notes
• You cannot use batteries other than the
"InfoLITHIUM" battery pack (P series) (p. 129).
• Do not short-circuit the DC plug of the AC Adaptor
or battery terminals with any metallic objects. This
may cause a malfunction.
• Use a nearby wall outlet when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
outlet immediately if any malfunction occurs.
Battery pack
DC IN jack
Power cord
To the wall outlet
1
Attach the battery pack by sliding it in
the direction of the arrow until it clicks.
16
Getting started
DC plug
AC Adaptor
2
With the v mark on the DC plug facing
down, connect the AC Adaptor to the
DC IN jack on your camcorder.
3
Connect the power cord to the AC
Adaptor.
4
Connect the power cord to the wall
outlet.
5
Slide the POWER switch up to OFF
(CHG) .
The CHG (charge) lamp lights up and
charging starts.
v mark
CHG
CHG (charge)
lamp