Diagnosis - Siemens SIMOTION Function Manual

Error messages / diagnosis

7.2 Diagnosis

Error no.: Meaning
hex (dec)
8386 (33670) The AS-Interface slave has invalid configuration data (I/O or ID codes).
83A1 (33697) The requested AS-Interface slave was not found on the AS-Interface.
83A2 (33698) An AS-Interface slave with address 0 exists.
83A3 (33699) An AS-Interface slave with the new address already exists on the AS-Interface.
83A4 (33700) The AS-Interface slave address cannot be deleted.
83A5 (33701) The AS-Interface slave address cannot be set.
83A6 (33702) The AS-Interface slave address cannot be stored permanently.
83A7 (33703) Error while reading the Extended ID1 code.
83A8 (33704) The target address is not plausible (e.g. a B-Slave address is used for a Standard slave).
83B1 (33713) A length error occurred during the string transfer to profile 7.4.
83B2 (33714) A protocol error occurred during the string transfer to profile 7.4.
83F8 (33784) The request number or the request parameter is not known.
83F9 (33785) The AS-Interface master has detected an EEPROM error.
9999 (39321) The number of repetitions for transient errors has been exceeded.
Retry request.
Table 7-2 Status messages
Error no.:
hex (dec)
Status messages (status parameter)
0000 (0)
8181 (33153)
8182 (33154)
7.2 Diagnosis
Definition of a diagnostic alarm
If the user program is to respond to an internal or external error, you can set the parameters
for a diagnostic alarm that will interrupt the cyclical program of the SIMOTION device.
Events that trigger a diagnostic alarm
The criteria (events) that trigger diagnostic alarms in a SIMOTION system are the same as in
a SIMATIC system.
More information is available in the following manuals:
● SIMATIC NET CP 343-2/CP 343-2 P, AS-Interface Master
● SIMATIC NET DP/AS-Interface Link 20E
40
Meaning
Request successfully completed
Command being processed
Status after reset
Extension to the command interface for AS-Interface master modules
Function Manual, 01/2015