Electronic Unit Injector - Install - Perkins 1106D Disassembly And Assembly

28
Disassembly and Assembly Section
Illustration 49
4. Place a temporary identification mark on the
connections (9) for the harness assembly (8).
5. Use a deep socket to remove the connections (9)
from the electronic unit injectors (10).
6. Use Tooling (B) in order to remove the torx screw
(11) from the clamp (12). Discard the torx screw.
7. Place a temporary identification mark on the
electronic unit injector (10). The electronic unit
injector must be reinstalled in the original location
in the cylinder head.
Illustration 50
8. Use Tooling (C) to pry beneath the clamp (12)
and free the electronic unit injector (8) from the
cylinder head.
9. Remove the electronic unit injector (10) and the
clamp (12) from the cylinder head.
Illustration 51
g01193293
10. Remove the sealing washer (13) from the base of
the electronic unit injector (10) or from the bore in
the cylinder head. Discard the sealing washer.
11. Remove the O-ring seal (14) from the electronic
unit injector (8). Discard the O-ring seal.
12. Repeat Steps 4 through 11 in order to remove the
remaining electronic unit injectors.

Electronic Unit Injector - Install

Installation Procedure (One
Injector)
Table 9
Tool
B
D
27610294
E
27610296
F
g01193295
Required Tools
Part Part Description
Number
-
T40 Torx Socket
-
Vacuum Pump
Tube
-
7.9 mm (0.31 inch) OD
Injector Pipe Nut Tool
Torque Wrench
SENR9983
g01193297
i02295941
Qty
1
1
1
1
1