Page 1
Wireless Speaker Getting Started USB Device Operating Instructions Tuner BLUETOOTH connection Sound Adjustment Other Operations Additional Information GTK-PG10...
Page 2
For customers in Australia WARNING Disposal of Old Electrical Do not expose the appliance to naked & Electronic Equipment flame sources (for example, lighted (Applicable in the candles). European Union and other European countries As the main plug is used to disconnect with separate collection the unit from the mains, connect the unit systems)
To avoid the deterioration of the Notes on water resistant water resistant performance feature Check the following and use the unit correctly. (Read before using the unit) • Be careful not to drop the unit or subject it to mechanical shock. Water resistant performance of the Deformation or damage may cause unit...
Page 4
Rear How to care for the system when If the system gets wet, first remove the water from the system, and then wipe off the moisture on the system using a soft, dry cloth. Especially in cold regions, leaving moisture on its surface may cause the system to freeze and malfunction.
About the BLUETOOTH wireless technology ....... 19 Playing back with high quality sound codec (AAC/LDAC™) ..19 Setting the BLUETOOTH standby mode ........20 Turning on or off the BLUETOOTH signal ........21 Using “Sony | Music Center” and “Fiestable” via BLUETOOTH connection ........21...
Guide to parts and controls Front Rear ...
Page 7
VOLUME –/+* buttons (power) button Press to adjust the volume. Press to turn on or off the system. MIC jack CHARGE indicator Use to connect the microphone. Lights up in amber while the battery is charging. ...
Page 8
Indicator statuses The statuses of the indicators on the unit are shown in the illustrations as follows. Indicator status Illustration Flashing Lit up Turned off...
Note Getting Started • It may take longer to charge the battery depending on the conditions of use. Charging the battery • Even if you do not intend to use the system for a long time, charge the battery to its full capacity once every six months The system can be used with the to maintain its performance.
Carrying the system Unfolding the top panel Before carrying the system, disconnect You can use the system as a table by all the cords. unfolding the top panel. To unfold the In addition, if the top panel of the unit top panel, push up the pawl () at the is unfolded, fold the top panel securely rear side of the unit and then unfold...
You can also check the battery in battery and the remaining battery level using “Sony | Music Center” level is less than 10%. (page 21). Press the button to turn on the system.
• Do not walk over the tripod legs to avoid Installing the speaker from tripping. • Disconnect the AC power cord (mains system on a tripod lead) and all cables, and detach the speaker system from the tripod when you want to move the tripod, speaker system Match the hole on the speaker system or the subwoofer.
USB device for details from a list of music on the USB on the operation method. device using “Sony | Music Center” • Do not connect the system and the USB (page 21). device through a USB hub.
Page 14
Note • This system cannot play audio files on the USB device in the following cases; — when the total number of audio files on a USB device exceeds 5,000. — when the number of folders on a USB device exceeds 999 (including the “ROOT”...
Presetting radio stations Listening to the radio You can store up to 20 FM stations as your favorite stations. To preset FM stations, use “Sony | Adjust the antenna for Music Center” on your smartphone/ optimum reception. iPhone. For details on “Sony | Music Center,”...
(BLUETOOTH) indicator on For details, refer to the operating the unit flashes slowly. instructions of your BLUETOOTH device. Select “GTK-PG10” on the display of the BLUETOOTH device. Hint BLUETOOTH When there is no pairing information on the system (for example, when...
Page 17
Erasing all the pairing Make sure that a BLUETOOTH registration information connection has been established. To erase all of the pairing registration Once a BLUETOOTH connection information, the system needs to is established, the system will be restored to the factory default emit a notification sound, and the settings.
Listening to music on a Start playback of an audio source on the BLUETOOTH BLUETOOTH device device. For details, refer to the operating instructions of your BLUETOOTH You can enjoy listening to music on a device. connected BLUETOOTH device. You can also use the button on Check the following before playing the system to play back/pause the music:...
You can select an audio codec option you can switch the BLUETOOTH from the following two settings input device by operating another by using “Sony | Music Center” connected device to start playback. (page 21). The default setting of this system is “AUTO.”...
This setting can only be configured by data than the other technologies, using “Sony | Music Center.” For details for transmitting over a on “Sony | Music Center,” see “Using BLUETOOTH wireless network with “Sony | Music Center” and “Fiestable”...
“BT OFF” appears on the display. You can control the system more flexibly and enjoy it in new ways using Note the free Apps “Sony | Music Center” • You cannot perform the following and “Fiestable” on your smartphone/ operations when you turn off the iPhone.
Page 22
Note Launch “Sony | Music Center” • If “Sony | Music Center” does not work and download “Fiestable.” properly, terminate the BLUETOOTH connection (page 17), then perform the BLUETOOTH connection again so that the BLUETOOTH connection functions normally. • What you can control with “Sony | Music Center”...
Sound Adjustment Adjusting the sound Do this Adjust the Press the VOLUME –/+ volume buttons. Reinforce Press the MEGA BASS bass sound button repeatedly to and create select “BASS ON.” The more MEGA BASS indicator powerful lights up. sound To cancel, press the (MEGA BASS) MEGA BASS button repeatedly to select...
Using an optional Other Operations microphone Using an optional equipment You can output your voice from the system by connecting a dynamic microphone with a normal plug (not Connect an optional supplied). equipment (i.e. WALKMAN®, Press the MIC – button to smartphone, TV, DVD player, reduce the microphone IC recorder, etc.) to the AUDIO...
To deactivate the buttons, hold make sure whether this function is down the FUNCTION PAIRING turned on or off by using “Sony | button and VOLUME + button for Music Center.” For details on “Sony | Music Center,” see “Using “Sony | about 3 seconds.
Saving the battery Checking the software power version You can save power and use the You can check the current version of system for longer periods of time the software on the system. by turning on the no display mode Hold down the FUNCTION (Power saving mode) when using the system with the built-in battery...
If a problem occurs while operating the system, follow the steps described compatible devices below before consulting your nearest Sony dealer. If an error message appears, be sure to make a note of the About supported USB devices contents for reference.
Page 28
(page 27). file. —The USB device is not recognized. • Set the play mode to normal play —Playback is not possible. mode using “Sony | Music Center” —The sound skips. (page 21). —There is noise. —A distorted sound is output.
Page 29
• Erase the pairing registration Files cannot be played back. information of the BLUETOOTH • USB devices formatted with file device by restoring the system to systems other than FAT16 or FAT32 factory default settings (page 30) are unsupported.* and perform the pairing operation •...
• Heat buildup on the system during • If the system doesn’t turn back on, consult operation is normal and is not a cause for your Sony dealer. alarm. • Pairing information is not deleted after • Do not touch the cabinet if it has been you reset the system.
Page 31
BLUETOOTH technology. • Sony cannot be held liable in any way Axis of vertical for damages or other loss resulting from rotation information leaks during communication using BLUETOOTH technology.
General Specifications Power requirements: North American model: AC 120 V, Speaker section 60 Hz Tweeter: Other models: AC 120 V – 240 V, 40 mm x 2, cone type 50/60 Hz Woofer: Power consumption: 180 mm x 1, cone type 30 W Standby power consumption: USB section and supported When BLUETOOTH standby mode audio formats and demonstration mode are set to...
Microsoft subsidiary. • The BLUETOOTH® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Sony Corporation is under license. Other trademarks and trade names are those of their respective owners.
Need help?
Do you have a question about the GTK-PG10 and is the answer not in the manual?
Questions and answers