Specifications; Troubleshooting - Honeywell DC915 Series Installation And Operation Manual
Portable, wired & wireless doorbell
Hide thumbs
Also See for DC915 Series:
- User manual (6 pages) ,
- Quick start manual (4 pages) ,
- Troubleshooting (2 pages)
Table of Contents
Advertisement
Reset
This process removes all pairings, including the push button that came with
this doorbell:
1. Remove the doorbell batteries.
2. Press and hold the Setting button and replace the battery at the same
time.
3. The halo light will circle and the doorbell is returned to its default factory
settings.
Specifications
Operating Temperature
Honeywell Home ActivLink™
Range (open field)
Sound Level (typical)
Battery Type
Battery Life (5 activations/day)
Rain proof
Troubleshooting
If
The doorbell does not work
Two 'beep' sounds are heard after
the normal tune
The halo light flashes yellow at
the bottom edge
Range is reduced
*Under these scenarios the push button is considered the "transmitter". Other examples of transmitters are the wireless motion
(PIR) sensor or wireless door window sensor.
www.resideo.com
https://livewell.honeywellhome.com
©2019 Resideo Technologies, Inc.
All rights reserved. The Honeywell Home trademark is used under
license from Honeywell International Inc.
32343181-001 Rev.A
Doorbell
-5ºC to 40ºC
868 MHz
200 m
90 dB
C cell alkaline (x 4)
Up to 5 years
N/A
1. Press the Mute button until all of the Mute lights are off.
2. Make sure that correct batteries (4 C alkaline cells, 1 CR2032) are installed with the
correct polarity.
3. The doorbell might be out of range; try the doorbell in a different location.
4. Reconnect the doorbell. See "Connect a Push Button" on page 8.
5. Check all the batteries and replace if needed.
6. Check if the confidence LED on the transmitters is working when activated.
7. Check if the doorbell is muted.
8. Check that the transmitter is linked with the chime.*
Replace doorbell push battery with a new CR2032.
Replace doorbell batteries with 4 new C alkaline batteries.
1. Metal structures including uPVC door frames can reduce the range. Don't mount the the
doorbell or doorbell push on or near metal structures.
2. Move the doorbell closer to the doorbell push button.
3. Weak batteries will reduce range. In cold conditions (below 5ºC), batteries may need to
be replaced more often.
Push Button
-20ºC to 50ºC
868 MHz
200 m
-
CR2032
Up to 2 years
IP55
Then
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DC915 Series and is the answer not in the manual?
Questions and answers
Doorbell keeps ringing continuously . Stopped it by taking batteries out.
The provided information does not contain troubleshooting steps for a Honeywell DC915 Series doorbell that keeps ringing continuously. However, you can try the following general steps:
1. Check the Push Button – Ensure it is not stuck or continuously pressed.
2. Replace the Batteries – Weak batteries in the doorbell or push button may cause malfunction.
3. Reprogram the Push Button – Remove and re-link the push button to the doorbell.
4. Check for Interference – Other wireless devices may be causing interference; try changing the location.
5. Reset the Doorbell – Remove the batteries and reinstall them after a few minutes.
If the issue persists, consult the user manual or contact the manufacturer.
This answer is automatically generated