Warning - Topcon GLS -2000 Series Instruction Manual

15.2 Warning

Type
Format failed.
SD card is not seated
Please re-seat
SD Card
SD card lacks space!
Change SD card
Failed to delete this file/
folder.
Data
selection
This file can't open!
Tilt Over
Tilt
Paused by vibration!
Message
An error occurred during
SD card formatting.
An SD card was not
recognized.
The remaining capacity of an
SD card is lower than
required for the data to be
scanned.
The file or the directory was
not deleted.
A file other than BMP or
JPEG is selected.
When the tilt sensor is set
to on, the instrument is tilted
at
At the [TILT 0 ADJUST]
setting, the screen will
display the tilt angle of
or more.
When the tilt sensor is set
to on, if vibration is detected
during scan or photograph,
those operations are going
to pause.
And if tilt value is stable
again, those operations
restart automatically.
This message is also dis-
played when the instrument
is tilted significantly.
15. WARNING AND ERROR MESSAGES
Description
±
6' or more.
±
30''
82
Countermeasures
Check that the SD card is
inserted correctly. If the error
persists, format the card using a
PC with the SD format tool pro-
vided by the SD Association on
the web. (Download from: https:/
/www.sdcard.org/jp/downloads/
formatter_4/)
If the SD card cannot be format-
ted using this tool, the SD card
may be broken. Use another SD
card. If the second SD card can-
not be formatted, have the
instrument repaired.
Delete unnecessary data in the
SD card or insert an SD card
with sufficient capacity.
Check that the SD card is
inserted correctly. If the error
persists, format the card using a
PC with the SD format tool pro-
vided by the SD Association on
the web. (Download from: https:/
/www.sdcard.org/jp/downloads/
formatter_4/)
If the SD card cannot be format-
ted using this tool, the SD card
may be broken. Use another SD
card. If the second SD card can-
not be formatted, have the
instrument repaired.
Select the BMP or JPEG file.
Accurately level the instrument.
If the operation does not
resume, it may be because that
the vibration is still continuing or
the instrument is being tilted sig-
nificantly.
Set the tilt setting off and start
those operation.