Getting Started; Powering Camera Unit; Wall Mounting Camera Unit - Infant Optics DXR-6 User Manual

3. Getting Started

3.1 Powering Camera Unit

1. Connect the Camera Power Adapter to the Camera Unit.
2. Slide the ON/OFF Switch to the On position. The Power LED light on the Camera Unit
will illuminate green.
3. Position your Camera Unit no less than 3 feet away from your baby's crib. Ensure the
power cord is not within reach of your baby.
NOTE
Only use the enclosed Camera Power Adapter (5.9V , 550mA).

3.2 Wall Mounting Camera Unit

Before installation, check the reception and camera positioning of the location you intend to
mount the camera by holding it to the wall. Ensure the desired location is no less than 3 feet
away from your baby's crib.
1. Pre-drill a hole in the wall using a 1/5 inch (6mm) drill bit.
2. Insert wall anchor into the wall and tap gently with a hammer until the anchor is flush
with the wall.
3. Insert screw into the wall anchor and tighten until the screw only sticks out by about
1/3 inch.
4. Connect the Camera Power Adapter to the Camera Unit.
6