i3TOUCH P7511 User Manual page 7

IDENTIFICATION OF CONTROLS
Connection Panel
1 Antenna
2 USB (Type-C)
3 USB
4 USB
5 HDMI OUT
6
7 HDMI1/2/3 INPUT
8 DP INPUT
9 PC IN
10 RS-232C
11 Earphone
12 S/PDIF digital audio output
13 TOUCH OUT 1/2
14 LAN IN
Note: If the VGA does not get any signal it will go into stand-by after two minutes, while others source
does not get any signal it will go into stand-by mode after 10 minutes.
Wi-Fi antenna. (Tighten the Wi-Fi antenna in clockwise direction)
Connect USB devices to this port for Android.
Connect USB devices to these ports for Android.
Connect USB devices to this port for Android. Note: use this USB-port for software updates.
Connect a monitor to this port, output of the currently screen.
Press to switch the screen on or off.
When the screen s turned on, press the button to show the Navigation bar.
Press the button for about 2 seconds and the screen will go into stand-by mode.
Connect a HDMI or DVI device to this jack.
HDMI 3(ARC): Connect an ARC-enabled home theater receiver to this jack.
Connect an external device to DP out jack.
Connect the video/ audio of a computer to these ports.
For remote control, service and other uses.
Connect headphones to this jack. The screen is the current audio output.
Connect a digital sound system to this jack.
Output for external devices connected to PCx, HDMIx or DP ports, which support touch
systems.
Connects the external network or the router.
The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are
trademarks or registered trademarks of HDMI Licensing LLC in the United States and other
countries.
7