Advertisement
062 LCD Oscilloscope
Assembly Notes
Applicable Models: 06203KP, 06204KP
Important Notes
1.
Some components shown in the schematic and PCB layout are for options or adjustments.
They do not necessarily need to be installed. Components to be installed are listed in the part
list. Please ignore those components that appear in the schematic but not in the part list.
2.
Users should pay special attention to polarity and orientation for some components. These
components include diodes, transistors, electrolytic capacitors, ICs, connectors, etc. Incorrect
installation of such components may result in damage of parts and malfunction of the
instrument.
Check Contents
Users are encouraged to check contents against the Part List before installation. If any
missing/broken
parts
(support@jyetech.com) immediately. Your email should include following information:
1)
Your name and contact method
2)
Vender's name
3)
Copy of receipt (or order confirmation) that indicates the contents and date of your
purchase.
4)
List of missing/broken parts and quantity.
Note 1: Power adapter is not included in the kits. Users need to prepare a 9 – 12 V
( >300mA capacity ) DC power supply
Note 2: J6 (RCA jack) is included in the kit for jury-rig. If more professional feel
is wanted there is a BNC Probe Kit (PN: 603-06201) available which
includes J1 (BNC connector).
Identify PCB:
Look at the back side (the side with many footprints for surface mount devices). On its top-left
corner you should see the PCB part number. It should be "109-06200-00C". If you see something
else then it will not match this instruction.
JYE Tech
are
found
please
Component locations (back side)
- 1 -
report
to
your
vender
DN062-18v03
and
JYE
Tech
www.jyetech.com
Advertisement
Table of Contents
Related Manuals for JYE Tech 062
Summary of Contents for JYE Tech 062
- Page 1 DN062-18v03 062 LCD Oscilloscope Assembly Notes Applicable Models: 06203KP, 06204KP Important Notes Some components shown in the schematic and PCB layout are for options or adjustments. They do not necessarily need to be installed. Components to be installed are listed in the part list.
- Page 2 (the middle hole and the hole with square pad) and to the height of about 0.3”. Then bend it outward to form a small ring. Step 8. Install voltage regulator U3 and its heat sink JYE Tech - 2 - www.jyetech.com...
- Page 3 Important Note: Cut all C10 and U3 leads flash to PCB to avoid short to LCD module. Now place the assembled LCD module into the main board. Solder the four corner pins first. Check to make sure the LCD assembly is fully inserted into the main board. JYE Tech - 3 - www.jyetech.com...
- Page 4 Check and make sure no leftovers (like cut-off pins) on PCB. Plug in power supply. You should see the boot sequence that briefly displays JYE Tech web address and firmware part number and enters normal operation. If LCD backlight is on but nothing displayed it could be the LCD contrast is not correct.
- Page 5 If you find some button don’t work you may need to release the screws a little bit. Revision History Version Date Summary 2010.04.22 First created 2010.07.09 Rewrote with more detailed instructions 2011.02.14 Added a note under “Check Contents” section for BNC connector J1. JYE Tech - 5 - www.jyetech.com...
Need help?
Do you have a question about the 062 and is the answer not in the manual?
Questions and answers