Advertisement
CRUSH ICE
1
Lay the appliance on the flat horizontal surface and make sure it is unplugged.
2
Prepare some ice cubes with a size of 15 mm x 15 mm x 15 mm. And then remove the
Measuring cup and Jug lid, after it, put the ice cubes into the Jug. Usually certain
amount of purified water has to be added to facilitate the smooth running of
appliance. The proportion of the ice and water is 2:3. The amount of mixture should
not exceed the max level as indicated on the Jug. And then close the Jug Lid and
Measuring Cup well in position.
3
Connect the appliance with power source, and then push the Power Switch to "ON"
position.
4
Turn the speed Switch to the "HI" speed setting or push the function switch to "Pulse"
setting and the appliance starts to crush ice.
5
After crushing ice for around 3 minutes, turn the speed Switch to "OFF" position, and
the appliance stops working.
6
You may add ingredients into the Jug through the center opening of Jug cover during
operation. Turn off the appliance to make it stop working, and then remove the
Measuring Cup and add the ingredients into the Jug through the center opening of
Jug. Then replace the Measuring Cup in position and turn on the appliance again.
Note:
• During operation, if the mixture is too thick to be crushed, operate by referring to the
description of "Tamper" mentioned above.
• Do not remove the Jug from the Motor Unit during working process. If it is necessary to
remove the Jug, please turn off the appliance to make it stop working and then remove it.
• The advisable operation time per time is 3 minutes and minimum 1 minute rest time must
be maintained between two consecutive cycles. Allow the appliance to rest for at least 30
minutes every 10 cycles.
7
After finish working, move the Jug out of the Jug Support Pad, and then carefully take
down the Measuring Cup and Jug Lid, then pour and serve.
CAUTION: The Speed Switch and Power Switch must be at "OFF" positions and the power
outlet must be unplugged before removing the Jug.
High speed blender_EMF2056.indb 9
High speed blender_EMF2056.indb 9
E-9
10/5/2016 10:29:28 AM
10/5/2016 10:29:28 AM
Advertisement
