EVERSPRING ES160 Manual

Z-wave
ES160
The ES160 is a PIR module to retrofit onto existing outdoor floodlight. It features a
PIR detector to detect motion through movement of heat sources and a lux sensor
for determining brightness of its surroundings. It is equipped with Z-wave
wireless communication capability to upgrade the ordinary outdoor floodlight into a
smart home device.
When not connected to a Z-wave network, ES160 when fitted on a floodlight is
fully operational as a standalone security floodlight. During hours of darkness its
PIR detector turns on the floodlight when it detects movement in the protected
area. Its built-in timer will then turn off the floodlight after a preset time has elapsed.
During daylight hours, its lux sensor saves energy by deactivating the motion
sensor and the floodlight. The lux level and the timer can be set through knobs on
the device itself.
When added into a Z-wave network, ES160 communicates directly with other end
devices such as smart plugs, or to report directly to a Z-wave controller (usually a
gateway). It alerts the controller when motion is detected and through Z-wave
commands, the controller can remotely turn on/off the floodlight at any time and be
able to configure its lux level and timer setting.
This product supports the S2 security protocol that uses encrypted Z-Wave
messages to communicate to other security-enabled Z-Wave
plus
security-enabled Z-Wave Controller must be used in order to fully utilize the
security features of this product.
ES160 can be installed on standard external outdoor lighting fixture without a
motion sensor, or to replace existing motion sensor on security floodlights.
Product Overview


 PIR Lens
 LED indicator (hidden behind lens)
 Link button
plus
outdoor PIR motion
detector module
plus


 Lux knob
 Timer Knob
 Threaded arm
Below diagram show a typical assembly of ES160 onto a floodlight fixture (fixture
is not included).
plus
(Wall mount)
Note: Please read this entire instruction manual before you start the installation.
IMPORTANT
Installation must be performed by skilled technicians who are informed
about the standards and technical requirements of the appliance and its
proper installation.
Check your local codes as they apply to your situation. If the house wiring is of
aluminum, consult with an electrician about proper wiring methods.
plus
products. A
Before proceeding with the installation, TURN OFF THE POWER TO THE
LIGHTING CIRCUIT AT THE CIRCUIT BREAKER OR FUSE BOX TO AVOID
ELECTRICAL SHOCK.
SAFETY PRECAUTION

DO NOT install when it is raining.

Isolate the power supply before installation.

Ensure that local Wiring and Building regulations are complied with.

The unit is supplied with a pre-wired supply cable this must be used and must
not be removed.

Total lighting load to ES160 not exceed:
- 300W incandescent @ AC120V

- 100W LED @ AC120V with 0.8 pF Driver

Installation & Wiring instructions
Note : As with any outdoor installation work it is always recommended to start
early during the day.
1
(Under Eave mounting)