Sending Data By Pda; Procedures For Data Transmission; Installing Activesync - Pidion BI-500 User Manual

BI-500 User Manual

Sending data by PDA

You can exchange data by connecting the terminal to the PDA supporting Bluetooth, without
the USB cable.

1. Procedures for data transmission.

① Install [Microsoft ActiveSync] in a PC. (See P-23)
② Connect the PDA and PC with the USB cable and install [PidionScan] in PDA, and
disconnect.(See P-35)
③ Power the terminal on. (See P-13)
④ Set <Bluetooth> of the PDA. (See P-31)
⑤ Set the [PidionScan] program of the PDA. (See P-35)
⑥ Scan barcode with the terminal. (See P-14)
⑦ Scanned barcode information is displayed in the screen of the [PidionScan] program or in
the Word/Memo of the PDA.
Tip.
• If the PDA and Bluetooth are properly connected, the Barcode reading communication lamp
turns blue, and high signal tone is generated once.
• Even if the Bluetooth transmission fails after barcode scanning, the barcode data is
automatically stored in the scanner.
• Because the Bluetooth interworking is disconnected while PDA is in Power Save
mode, do not use Power Save mode when interworking with Bluetooth.

2. Installing ActiveSync.

To install the [PidionScan] program in the PDA, install the [MicroSoft ActiveSync]
program in a PC.
If the [ActiveSync] program is already installed in the PC, you need not install the program
separately.
The seen screen corresponds to the [Microsoft ActiveSync 4.5] version and it depends on the
software version used.
① Access the Microsoft's Website, and download [Microsoft ActiveSync], and install.
Empowering Mobility Page 24 of 47 Bluebird Soft Inc.